I do have a solution for you, but when I spoke with my contact at Air Lift she said that the frame on your 2017 GMC Canyon with the diesel engine is slightly different. Because of this the Ride Control #AL59533 you referenced doesn't line up…
The need for an accumulator tank like the Seaflo Accumulator Tank #SE38FR with the Excel RV Tankless On-Demand Water Heater #EX93FR would depend solely on the pressure of your water pump. This water heater requires a water pressure of 2 psi up to 120…
The 2016 Chevrolet Colorado does not have a plug-in adapter for a brake controller such as the Tekonsha Prodigy P3 Trailer Brake Controller part #90195. However, the wires that will need to be hardwired into the adapter are already present on the…
The Dometic RV Water Heater #DMC74FR can replace your Atwood G6A-8E but it is quite a bit smaller so you'll need to use the Water Heater Door Conversion Kit for 6 Gallon Electric and Gas Water Heater #DMC84FR to fill in the gap left behind.
Hey Dean, so the install is super easy for the Agri-Cover SnowSport HD Utility Snowplow #SS48GV (which is what I assume you were looking at) - you just slide everything into your receiver and set the height. For the weight, it's not terribly…
I took a look at your order and it was the Rhino-Rack Roof Rack for Factory Tracks - 54" Bars #Y02-480B-NT which is too short for the 63 inch spacing on your truck. For that spacing you will need the following: - Rhino-Rack Roof Rack for Factory…
Yes, the 63" Rhino-Rack RTC-Style Roof Rack Tracks - Channel Mount part #RTC16 can be cut down to the size you need as long as you cut them perfectly straight to allow the end caps to go back on because at this time we do not carry them as a…
Hey Kevin, it sounds like you are looking for the Hopkins part #HM45MV that you referenced. This will replace your current 7-way with a 7-way that has a 4-way built into the side of it.
Although it's never been tested yes, the Thule Tracker Fit Kits would fit in the track part #RTC16 as the Thule also uses track nuts that are 3/4 inches wide like the Yakima towers.
The Curt Trailer Hitch Receiver Adapter part #C45785 will reduce the tongue weight capacity of your trailer hitch by 50% according to the manufacturer. This same statement holds true for pretty much any other hitch adapter like this no matter the…
The The Brophy Camper Tie Downs #TDSF, are a universal fit kit intended to fit as many trucks as possible. While there is nothing to say that it for sure fits, looking at your pictures it seems likely that it will work for your 1968 Ford F-250 Camper…