Yes, David you are correct. The Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness item #RED82CR is exactly what you need. Since your 2024 Toyota 4Runner came with a 7-way connector, the plug and play adapter included with item #RED82CR will…
Thanks for the pictures! It looks like you have a 3" x 5" channel so the Dexter DX7.5L A-60 Brake Actuator item #DX33FR will work for you. You will need to measure the width of the top of your channel to confirm this will fit.
Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…
The inner diameters of the LM67048 and 15123 both are the same (1.250 inches). That means that a hub with either bearing in the outer bearing would fit your spindle. The part #AKHD-655-6-EZ-K would fit your axle.
The short answer is Yes, bearing #15123 is slightly larger and stronger than #LM67048 and they use different races which means they are not interchangeable. Bearing 15123 uses race #15245 which has an outer diameter of 2.441 inches and bearing…
I have seen several people use the Mounting Bracket #HM40978 to relocate the 7- and 4-Pole Trailer Connector Socket #HM40975 on their 2019 Toyota 4Runner to a more easily accessible location. I have linked a image below showing where they remounted…
On a 7-Way connector the suggested minimum wire gauge for the White (ground) wire, the Red or Black (power) wire, and the Blue (brake power) wire is 12 gauge. The minimum wire gauge for the remaining Green (right turn/brake) wire, the Yellow (left…
I attached a picture that shows all of the pin dimensions of the Aries step pad part #AA2090139 which you'd be able to use to determine if this is correct for your step bars. The overall length of the pad is 21-1/4 inches and the width is 3…
There are two ways to wire up two batteries. One way doubles the volts of the two batteries and the other keeps the same amount of volts. In parallel the voltage stays the same and in series it is doubled. Check out the diagram for more info.
For a typical travel trailer propane setup you will have 1 of 2 pigtails. The first will have the Type 1 connector (with the green cap) and the other has a 1/4" MPT fitting like what we find on the pigtail #100473-12. I believe this is what you…
All of the RV regulators we carry are going to work down the output pressure to 11" water column. That pressure will always stay the same but the amount of BTU's you can spread between the appliances can vary depending on the regulator. For…
