The #30717 is exactly what you're looking for as long as you don't need the 7-way to supply anything other than lights on the trailer. You just plug the 4-ways together, connect the white ground wire to the vehicle's frame using the…
We can get you set up with a 7-Way trailer connector and a brake controller for your 2008 Jeep Commander, no problem. First, you will need to install #118408 which will provide the light functions to the 7-Way. Once that is installed you can then…
The 2008 Jeep Commander doesn't have the plug under the dash for a plug and play brake controller installation, so you'll need to hard wire the brake controller. There are two possible installation scenarios: If the Commander has the OEM…
Although your 2007 Jeep Commander is equipped with the Mopar tow package, it isn't fully wired with a plug-and-play connector under the dash. Jeep ran the brake controller output wire from the 7-way up into the passenger compartment, look for a…
I do have a way for you to use your Avail tow bar with a 3-inch hitch receiver, however, there are no replacement shanks that fit a 3-inch hitch receiver. All you need to use a tow bar that fits a 2-inch hitch receiver in a 3-inch hitch receiver is…
To determine the correct wiring for your trailer you will need to use a circuit tester, item #PTW2993, and attach the wires from the connector by function only. The light wires should be as follows, red is the stop turn wire and the black is the…
The Custom Mounting Brackets #K284104 are a little different than the majority of the other mounting brackets that Detail K2 offers. This kit actually wedges between parts of the frame on your 2006 Jeep Commander. Once the mounting brackets are in…
