Custom Fit 2002 Dodge Ram Pickup Accessories

Your slide-in truck camper does not have electric brakes so the blue brake circuit wire from its 7-way connector is not used. All other lighting functions as well as 12V auxiliary power will be maintained on the other circuits. Please refer to the…

The Timbren Rear Suspension Enhancement System item #TUR350 requires a minimum 5" space between where you mount the 4 1/2" x 4 1/2" bracket to your frame and axle pad. This allows the springs to have a 1" gap. The…

The part number 8-245 is an obsolete part number but I was able to find some info on it. It was basically a 3,500 lb hub and drum that fit a 84 spindle. Because of that we have a solution that will fit. The part #AKHD-545-35-K is a 3,500 lb…

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

The disc brake kits like #K2R1058D13 are designed for torsion axles and disc brake rated EOH systems which have a higher 1600 psi level than drum brake actuators. This is currently the only kit we have compatible with 10K torsion axles from Lippert…

To get the best braking power for your boat trailer you would want to have disc brakes on both axles. If you happen to be limited to one axle then you would want the rear outfitted. With a 5,000lb boat you likely have two 3,500lb torsion axles. The…

The best option for wireless brake controllers is the Curt Echo #C51180. It is the easiest to plug in and go when you need to use a brake controller with your trailer. Once you have a 7-way connector installed in your vehicle, all you need is to…

The red wire on the brake controller connects to the stop light wire on the brake switch located above the brake pedal. You will need to use a circuit tester like #PTW2993 to probe the wires. You need the one that shows a signal ONLY when the brake…

The Curt weight distribution shank part #C17123 that you referenced does fit Husky weight distribution heads like what you have and will sit at least 3 inches lower than most standard shanks so this would fit and work well for you.

I contacted our representative at Hidden Hitch about the Draw-Tite Trailer Hitch, part #24677. The representative at Draw-Tite informed me that the thickness of the tubing for part #24677 is 3/16 inches. The arms of the hitch that connect to the…

The hub you want as a replacement for what you sent in a picture of is the Kodiak Trailer Idler Hub Assembly #Q-HUB84545 which is a galvanized hub for a 3,500 lb axle with a 5 on 4-1/2 inch bolt pattern.

You can install different hubs with your preferred 5-on-4-1/2-inch bolt pattern on your existing Dexter axles so long as the new hubs use the same bearing set as the originals. This will ensure that the new hubs, such as Dexter #84545UC1-EZ that you…