Hey Sean, yes you can definitely use a stand alone system like a single-acting hydraulic pump to power a hydraulic trailer jack like the single action Stillwell lineup we just started carrying. For the Stillwell Atlas IV 10K Hydraulic Trailer Jack w/…
For your Edge Evo HT 36030, I recommend using the same setting as you would for any of the tuners when hauling a load. I recommend using the "Tow" setting for light load tow.
Hey Bryon, Yes, even when the air springs are deflated down to the 5psi users have noted that there is still a difference in the unloaded ride quality. The severity of that difference depends on a lot of different factors, but I've mostly seen…
Hi Joe, Hellwig does actually make the EZ-990 helper springs that fit your 1999 Dodge Ram 1500, with the Hellwig EZ-990 Helper Springs - Above Axle #HE68VR. These are also the most budget-friendly option for you.
The truck owner's manual is the best place to confirm its capabilities, such as towing capacity, but if this is not available the best alternative is to contact a dealership with your truck's VIN. This allows the dealership to see all of the…
I have a solution for you, but the Edge Module part #EZD1000A is not a fit for the 2005 Dodge Ram Cummins. Instead you would want the #EP36040 if you have the 325 horsepower Cummins or the part #EP30204 for if you have the Common Rail 24 valve that…
I checked out the installation instructions for the EvoHT2 Tuner, part #EP36040 and found that on page 18 it is explained how to return the engine tuning to stock. From the main menu you will need to select 'Tune Vehicle'. Then select…
Your Edge EvoHT2 #EP36040 is also a confirmed fit for your 2001 Dodge Cummins. This controller is only able to be used on one vehicle at a time, so setting that tuned vehicle back to stock will allow it to be used on another vehicle. Since he said he…
The Correct Track Tandem Lift kit part #RR23QX cannot work with the CRE3000 kit you have on your trailer now due to clearance issues so you would need to replace them with like with the EquaFlex part #LC145546 which is also cushioned.
I can definitely help you with your Voyager on your 2002 Dodge Pickup. It sounds like they might have spliced into the wrong wire at the brake light switch. I would start by testing the red wire behind the brake controller and if that has power when…
The correct adapter to install the Brake Controller part #39510 you referenced in your 2001 Dodge Ram 1500 is the part #3020-P. This adapter plugs into the 4-pin connector on your vehicle's built-in brake control wiring harness. The harness is…
