Comparing the Tekonsha Voyager ID And Redarc Brake Controllers Video

When installing the Universal Installation Kit for Trailer Brake Controller #ETBC7 it isn't necessary to connect the ground wire from the brake controller directly to the negative terminal on your vehicle battery - just find a sufficient mounting…

Hey Clay, to install a Tekonsha Voyager Id in your 2020 GMC Yukon you would need the part #TK26BR for the brake controller and then the part #3016 for the install harness and you'd be set. What will you be towing?

Hey Marco, thanks for reaching out! To get all of the wiring and such on your 2017 Hyundai Santa Fe you'll need the following: - Curt Wiring Connector #C59236 - Universal Installation Kit #ETBC7 - Tekonsha Voyager iD Brake Controller #TK26BR -…

If the 7-Way trailer connector on your 2016 Honda Pilot is the factory installed 7-Way then all of the functions, including the 12 volt power circuit, should be active. But on models that did not come with the factory harness the connection and…

Hello Mike, Sounds like you are getting things set up the right way and not going over your payload, I respect that. It looks like the weights are the same whether you have a 6 3/4' or 8' bed. If you happen to have an aftermarket hitch,…

We have two Class III 2-inch hitches that will fit underneath the OEM 1-1/4 inch hitch. One from Curt, #C13651, and one from Draw-Tite, #75751. Either of these hitches will fit just fine with the factory hitch. However, you cannot use both the Class…

It's not likely your International has a factory connector for an electric brake controller adapter. But you can still install a Prodigy P3 #90195 by hardwiring it into the RV. You will wire the P3 in by connecting the black wire to the positive…

There are some connections under the hood that will need to be made to complete the installation of the Tekonsha P2 Brake Controller #90885 with Wiring Harness, #3025-P. Once you have plugged in the #3025-P harness into the port to the left of the…

The Prodigy P3 Brake Controller part #90195 needs to be wired to the cold side of the brake light switch which is normally located near the brake pedal. You would need to test the wires at the brake pedal for the wire that only shows power when the…

It sounds like you've got a Thomas Payne Seismic Dual Power Reclining RV Loveseat w Console, Heat, Massage, LEDs like the #195-091-092-090, and you need the power plug for it. In this case you'll want to use the Replacement Power Cord with…

Hey John, so the #ETBC7 that you referenced is the correct kit to convert your 4-way to a 7-way and wire in a brake controller so you are on the right track. So then for a brake controller I really like the Redarc Tow Pro Liberty part #RED52VR which…

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…