Instructions for Installing Pop & Lock Custom Tailgate Lock # PAL3300 on 1995 Dodge Ram Pickup

Question

Question:

1995 Dodge Ram 1500. On the inside of the tailgate there are three bolts, does one of these have to come out to bolt pop and lock in? My gate has sprayed in bed liner over these bolts which will make removal more time consuming. Just wanted to know what lies ahead. Which of the bolts will have to come out.

asked by: T. L

1

Helpful Expert Reply:

When installing the Pop & Lock Custom Tailgate Lock, # PAL3300, on your 1995 Dodge Ram Pickup you will need to remove the lower of the three bolts and loosen the other two. I have attached installation instructions for you.

expert reply by: Leah S

1

click to enlarge

Answer 1

I think your plan should make your new tailgate basically theft-proof. The Pop & Lock Custom Tailgate Lock #PAL3300 that you referenced is confirmed to fit the tailgate of your 2001 Dodge Ram 1500 and honestly any qualified mechanic should have…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 6

Hey Ian, great to hear from you again! The differences between the MORryde CRE3000 #MR87ZR and AllTrek 4000 #MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will…

view full answer...

Answer 7

Hey Kyle! The Pacbrake Alpha HD Air Bag Suspension Kit #PB22RV installs in the same location as most fifth wheel and gooseneck brackets. I would expect to have to do some drilling to install these with your B&W Turnoverball. Instead, I recommend…

view full answer...

Answer 8

Hey Greg, you shouldn't need any wiring extensions with the install of the Happijac extension brackets #HJ54FR. If you check out the attached picture you can see where a customer of ours installed these brackets and had more than enough wiring…

view full answer...

Answer 9

Hello Bob, thanks for reaching out. We do have a lock that will work with the etrailer Adjustable 2-Ball Mount #e66PR. For that I recommend the following: - etrailer Hitch Receiver Lock for 2" and 2-1/2" Hitches - Flush - 3-5/8" Span -…

view full answer...

Answer 10

Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…

view full answer...

Instructions for Installing Pop & Lock Custom Tailgate Lock # PAL3300 on 1995 Dodge Ram Pickup

Product Page this Question was Asked From

Continue Researching