Jeep Spare Tire Carrier Specs:
Jeep Spare Tire Carrier Specs:
Features:
The Westin WJ2 Spare Tire Relocator allows Jeep JL owners to accommodate a tire up to 37" in diameter while maintaining factor design elements such as rearview camera and third brake light functionality. Steel plates provide added strength.
More Information >Videos
for Jeep Spare Tire Carrier
Help Articles
for Jeep Spare Tire Carrier
Expert Answers
for Jeep Spare Tire Carrier
The Lippert Flow Max RV Toilet #LC67AF requires a minimum of 12" for the rough-in.
view full answer...To flat tow your 2024 Jeep Wrangler Unlimited you will need the following parts: Tow Bar and Safety Chains - Roadmaster Falcon 2 Tow Bar item #RM-520 and item #RM-643 Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item…
view full answer...Yes, the Roadmaster Spare Tire Carrier #RM-195125 will work on your Jayco Melbourne motorhome, and it is straight out so it won't lower where the factory receiver is. Keep in mind the receiver on the spare tire carrier is for accessories…
view full answer...There are two possible options for you. The Dexstar Dual Wheel #AM20790 which is the 16" x 6" size you need with the 8 on 6-1/2" bolt pattern, uses flange nuts instead of standard lug nuts, and would work with…
view full answer...We have a number of spare tire carriers available from Roadmaster, Demco, and other manufacturers; However, Blue Ox does not build an option. If you are needing a spare tire carrier for your 2017 Jayco Redhawk Motorhome, may I suggest the…
view full answer...It depends on what 5th wheel landing gear you have. For example; the Lippert Landing Gear part #LC333966 is rated for 6,000 lbs. It can be used with a trailer that weighs more than 6,000 lbs because it is only supporting part of that load - the…
view full answer...For the 6-point Level-Up System by Lippert, I made a call to the manufacturer to ensure you would receive correct information. Lippert said that when you bolt the footpads to the jacks, you need to torque them to 132 ft-lb. They said to make sure…
view full answer...In order to add a 7 way connector on you 2020 Jeep Wrangler JL you'll need to start by adding a 4 way trailer connector like the Tekonsha #118786, which gives you the connections needed to install a 7 way connector. Once you've…
view full answer...The Lionshead Steel Dual Wheel, 4.77" Pilot - Silver, Item #LHHA420 is a 16" x 6" wheel with an 8 on 6-1/2 bolt pattern, so as long as your Class C motorhome wheels have the same bolt pattern and are the same 16" x…
view full answer...I reached out to Roadmaster who said the plate is 5-1/4" from the inside of the upright on the Spare Tire Carrier #RM-2000-7. Your 235/65R18 tire has a width of 9.3" and the 51mm offset is approximately 2" off the center…
view full answer...The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…
view full answer...I have included a picture that shows the measurements needed for a spindle, bearings, seals, faces, and hubs. The spindle measurements are labeled A through F. A is the spindle shaft diameter B is where the grease seal sits C is where the inner…
view full answer...Filter Products (4)
Contact and Help
What our customers are saying:
Great product. fast, professional, and well communicated service. it was a pleasure buying from y'all. thanks again
Tom
Fort Collins, CO