2004 Ford Ranger Truck Bed Sliding Tray

Hey Scott, the correct factory mount install kit for a BedSlide for a 2026 GMC Sierra 3500 would be the part #BE45UV. Do you have a BedSlide already?

Hi Kristian, great question! The etrailer Anti-Rattle Hitch Collar, part #e55YV, works by taking the slack out between your hitch receiver and the shank of your ball mount or hitch-mounted accessory. It clamps around the outside lip of your 2-1/2…

Hey Scott! The etrailer Anti-Rattle Hitch Collar #e55YV is rated for up to 10,000 lbs gross trailer weight and won't reduce the capacity of a properly matched towing setup. As always, your actual towing capacity is determined by the lowest-rated…

Hey Mike, congratulations on the new truck! You can definitely use the two together. The Curt StowPro 2-Ball Mount #C34FR53HY uses a standard 2-1/2" shank, making it a great match for our etrailer Anti-Rattle Hitch Collar #e55YV. It installs…

Hey Greg! The etrailer Anti-Rattle Hitch Collar for 2.5" Hitch Receivers #e55YV is not compatible with a weight distribution hitch. This is really the only restriction for our anti-rattle. If you need an anti-rattle for a weight distribution…

Good question, Aaron. Since your main detail is the GM MultiPro tailgate, I’d be careful here. The B&W Tow & Stow for 2-1/2" receivers #BWTS20066BMP is specifically listed as compatible with the GM MultiPro tailgate, so if tailgate…

Hey Raphael, it takes about 15-30 minutes roughly. It's not hard at all and uses basic tools (9/16" socket/wrench and tape measure). A battery-operated drill could definitely speed up the process. It's just a one person install. And yes,…

Hey Victor, welcome back. There are no custom fit aftermarket hitches available for a 2010 Chevy Suburban 2500. The factory hitch on your SUV was built into the rear bumper so none of our vendors made a replacement for it. To add a class V hitch…

Hey Richard, yes the Blue Ox Apollo part number BX7470P is the same as our part #BLU43QV. We change the part number just to organize it better in our system. This tow bar will also work with both base plate kits you mentioned part #BX1633 and…

Hey Max. To attach the T-One Vehicle Wiring Harness item #118648 to your new Curt Hitch item #C13343, you'll need the No-Drill Mount Bracket item #18136 and the Mounting Bracket 4-Pole Flat item #18144. The No-Drill Mount Bracket item #18136 uses…

Hey Mark, there isn't a way to use a Bedslide with a gooseneck but I was able to find that there is a way to use a CargoGlide with one if you use the part #CGGN-1 which is something that has to be special ordered from them. At this time we…

Hey Gary, thanks for reaching out, and thanks for your patience as I looked into this. I spoke with MouseBlocker directly and they said as long as you're connected to shore power then your best bet is to use the 1000x #MB54FR on the inside of the…