1990 Chevrolet Van Salt Spreader

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey John, so the correct amount of spring bar tension will be based on the trailer's tongue weight and how it affects the suspension of your Nissan Frontier. Every WD system is a little different but what it comes down to typically is…

I have included a picture that shows what Curt hitch #C13140 looks like when installed on a BMW X1. The picture is from the instructions which I have also linked for you. As you can see the receiver opening is the only part visible beneath the rear…

An Inno rack for your 2016 Mazda CX-5 would work great to carry the Rola cargo basket part #59504 that you referenced. For that you'd want the part number #INB127 and #INFR for if you have raised side rails or the part #INB127, #INSUT, and…

Yes, there is a trailer hitch that fits your 2024 Honda HR-V. The Curt Trailer Hitch Receiver #C68DR will fit and provide you with a 1-1/4" hitch receiver. I am guessing that by "smaller hitch", the 1-1/4" hitch is what you meant.…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

We sure do! The correct replacement slide out motor for your Power Gear 1510000042 is part #LC88UD on our site.

There is no adapter available that will go from a 7-Way vehicle side connector to a 6-Way square Jayco connector. You will need to make one using the follow parts: 7-Way trailer connector #H20042 6-Pole Square Trailer Wiring Connector Kit, #37995…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Since your 2022 Mercedes-Benz Sprinter 2500 did not come with the factory tow package you may not have a connector for the brake controller under the seat or under your dash. I have linked an installation video for the Redarc #RED44FR at the bottom…