Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Brandon, Yes, we do offer the 010-11088 under the Grease Seal Kit- Triple Lip #DX49CR. This comes in a quantity of two seals per kit.
view full answer...Hey C Fisher, the #TC3229SCAM version just has cam tensioners on it which does not make it on road use only. That fit note that it is for on-road use only is not accurate and of the two this would be what I would recommend since they are a bit easier…
view full answer...I went out to our warehouse and measured the Pipe Mount Swivel Jack w/ Footplate part #TJP-2001-B for you. The overall height of this jack from the bottom of the footplate to the top of the handle is 17". This jack has a 3,000 lb support and…
view full answer...The pipe mount replacement for the Round, Pipe Mount Swivel Jack #TJP-2001-B that you referenced is the part #TJP-IP916.
view full answer...The pin in the Etrailer Weld-On Swivel Jack, #TJP-2001-B, measures 1/2 inch. The attached photo shows more dimensions of this jack for you to review.
view full answer...We do not have a seal that matches the inner and outer diameter you have provided. That being said, I believe the markings on the seal actually indicate that your ID is 1.25" and our OD is 1.979". Your measurements are incredibly close to…
view full answer...The Curt Front Mount Trailer Hitch Receiver #C31033 has a line pull strength of 9,000 lbs. Since your 2014 Jeep Grand Cherokee Summit has a curb weight between 4,725 lbs and 4,955 lbs this hitch can be used for recovery. Typically a winch like part…
view full answer...Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
view full answer...The correct replacement coiled lighting wire for the Roadmaster Nighthawk part #RM-676 is the part #RM-1676-7R.
view full answer...I confirmed with Roadmaster that the capacity of the Roadmaster Safety Cable Anchors for Quick Disconnects Item #RM-910648 that you referenced is 8,000 lbs combined.
view full answer...When installing The etrailer Hitch #e95ZR onto your 2023 Hyundai Palisade, it does require some fascia trimming but it is not too bad. When looking at the instructions box 3 while using a tape measure, marker, and utility knife measure, mark, and…
view full answer...We have a couple options on trailer hitches that are confirmed for your 2023 Palisade, which are The Curt #C13427, and the etrailer #e95ZR The two hitches are indeed very similar but each hitch has something the other does not. The Curt Hitch #C13427…
view full answer...