Overall Height of the Pipe Mount Swivel Jack w/ Footplate Part # TJP-2001-B
Published 11/30/2017
Products Featured in This Question
Question:
I'm going to order the jack as soon as I can get the part number for an additional same sized pipe mount.
asked by: Paul D
Helpful Expert Reply:
I went out to our warehouse and measured the Pipe Mount Swivel Jack w/ Footplate part # TJP-2001-B for you. The overall height of this jack from the bottom of the footplate to the top of the handle is 17". This jack has a 3,000 lb support and 2,000 lb lift capacity with height adjustments from 11" - 21-3/4".
I have attached photo showing this measurement for you as well.
Product Page this Question was Asked From
Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Zinc - Topwind - 10-3/4" Travel - 2K
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 11 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: weld on jack pipe mount
- Search Results: d ring
- Search Results: tow hook
- Search Results: trailer jack pipe mount
- Shop: Bulldog Replacement Pipe Mount for Swivel Jacks - 2-1/4" Male - Weld On - 5/8" Pull Pin
- Shop: Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Zinc - Topwind - 10-3/4" Travel - 2K
- Video: Let’s Check Out the Round, Pipe Mount Swivel Jack w/ Footplate
- Q&A: what is the diameter of the Pin on the Etrailer Topwind Weld-On Swivel Jack
- Video: Checking Out the Replacement Male Pipe for etrailer and Ram Pipe Mount Swivel Jacks
- Q&A: Replacement Pipe Mount Recommendation for Round, Pipe Mount Swivel Jack # TJP-2001-B
- Shop: Replacement Male Pipe for Curt Pipe Mount Swivel Jacks - 2"
- Shop: CargoSmart Forged Steel D-Ring Tie-Down Anchor - Weld On - 5/8" x 4-1/4" - 5,000 lbs
- Shop: Bulldog Replacement Pipe Mount for Swivel Jacks - 1-7/8" Male - Weld On - 9/16" Pull Pin
- Shop: Replacement Male Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 2"
- Shop: Replacement Male Pipe for Curt Pipe Mount Swivel Jacks - 2"
- Search Results: trailer jack
- Shop: Brake Controller
- Video: Review of Tekonsha Trailer Brake Controller - Voyager iD Proportional Brake Controller - TK26BR
- Search Results: 47185
- Search Results: deka wire
- Q&A: 45 Amp Converter with Charge Wizard Needed for RV and Lithium Batteries
- Q&A: Solution to Replace WFCO 8735P to Charge Lithium Batteries
- Video: Hands-On with the Round, Pipe Mount Swivel Jack w/ Footplate
- Video: Breaking Down the Round, Pipe Mount Swivel Jack w/ Footplate
- Q&A: Will etrailer Solar Charging System Work With Shore Power/Vehicle Charging
- Shop: Trailer Wiring
- Video: Remove and Reinstall a Trailer Hub Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is Width of etrailer Single Axle Fender to Center from Mounting Bracket
- Video: Ultimate Overview of the Jack Mounting Bracket for Fulton Marine Jack
on Trailer Jack
Paul
11/30/2017
I'm going to order the jack as soon as I can get the part number for an additional same sized pipe mount.