If your 2008 Toyota Tundra has the factory 7-way connector in the back, then you should be able to plug in a brake controller adapter under the dash of the Tundra. Does the connector provided by the manufacturer look like the Universal Brake Control…
Your 2016 Isuzu NPR will need a weld-on trailer hitch, and there are a couple of options from Draw-Tite, which is the same manufacturer as Reese hitches. Based on my research, a '16 NPR has a 33-1/2 inch chassis width, so you can choose from…
Hi Charles, While we don't currently offer the inner member that you're needing for the UFP A-70 we do offer a compatible replacement with the Dexter DX7.5L A-60 Brake Actuator #DX33FR. This is the entire actuator assembly along with the…
On a 7 pin round which is the common connection on a semi trailer, the clearance/marker lights are at the 10 o clock position when you look at the trailer wiring connection. When looking at the connector on the back of the truck, that will put the…
While we don't have replacement parts for a Model 70LP actuator, we do have a great replacement for it. Like the 70LP, these actuators are a fit for a 2" hitch ball, but they just have a slightly larger capacity at 7,500 lbs. You didn't…
I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
The cut out dimensions listed for the JR Products Switch part #37213815 are right at 3/4 inches wide by 1-1/2 inches tall that we measured when we had one out.
Either way is correct. It depends on if you want to keep the semi-style 7-Way (if you need to tow that type of trailer) or if you will never be towing a semi-trailer. If you need to keep the 7-Way semi active on the truck, then you would need to make…
Hi Reuel, The Buyers Products 2-Way Die-Cast Zinc Trailer Connector #337TC1012 pins are labeled positive and negative on both the front and back. To connect the wires you'll just need to remove the two bolts in the back and slip on some ring…
You might be able to look at the manufacturer of the connector on the lid to see if you could contact them. Or you could keep the #337TC2012 and instead replace the female connector you have now with the part #337TC1012 which matches.
To replace your TDE Model LP7000 actuator, I recommend the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout item #DX89FR. This coupler is designed to mount on top of a standard 3" wide trailer tongue. It measures right at 3-3/8" wide so…
Typically if the baseplate doesn't have a nice spot to mount the breakaway we just screw it into the fascia using the small bracket that comes on the switch. If we're needing to space it out a bit we typically use a bracket like #18140 and…
Filters
