Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The difference between the etrailer #e95ZR and Curt #C13427 trailer hitches for your 2023 Hyundai Palisade is literally just the finish. The etrailer hitch has a matte black finish while the Curt hitch has the classic glossy black finish that we see…
view full answer...When we installed the Curt Hitch #C13427 on our 2020 Hyundai Palisade, the distance from the center of the hitch pin hole to the edge of the rear bumper is 5-1/2". That's slightly further out than the other hitch you were looking at. My…
view full answer...Hey, Stephen! We got just what you need. Since you don't have a tow package, I'm not sure if you have a hitch on your 2025 Ford Ranger so I'll include one just in case. Draw-Tite Max-Frame Trailer Hitch Receiver Part #DT35PR Curt…
view full answer...What you are looking for is a Torx wood screw based on the picture you sent to me. For that we have the 1-1/2 inch long part #TFX150ACQ which would work well. It has a 1/4 inch diameter and was designed for treated wood like it looks like you have as…
view full answer...As long as your truck originally was a cab and chassis model of truck before the dump bed was installed the Buyers Products Hitch Plate with Receiver Tube - Chevy/GMC #3371809065 that you referenced would fit and work well.
view full answer...For your 2020 Hyundai Palisade Limited edition you will need a wiring kit to transfer the light signals to your trailer, the pre-wiring provides a plug for the trailer wiring to hook up. I recommend Curt T-Connector Vehicle Wiring Harness #CU94FR. It…
view full answer...Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…
view full answer...Hey Asa! I totally see where you're coming from, and I can see why it would be confusing. The gray plug will plug in at the back of your 2024 Ford Ranger, and then the black wire from the Curt T-Connector #C96GJ will need to draw power directly…
view full answer...When it comes to replacing your trailer wiring on your 16 foot trailer I recommend The 7-Way Molded Connector w/ 15 foot Cable - Trailer End #50-67-106 will work. It is 18 foot and the wire gauges are as followed: Black/White - 10 Gauge Blue - 12…
view full answer...I can definitely help you out with that. On my end, I could not find a Hopkins 7-pin SAE J1128. With that being said, the most common 7-way on your F-350's end will look like the pins on the 7- and 4-Pole Trailer Connector Socket w/ Mounting…
view full answer...The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…
view full answer...According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…
view full answer...
Filters
