Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Fulton F2 Swing-Up Trailer Jack you referenced, part #F1413040134, has according to my contact at Fulton a bolt pattern of 3.44 inches X 4.44 inches measured precisely from hole center to hole center, top to bottom and side to side, respectively.…
view full answer...To attach the Fulton F2 Jack part #F1413040134 to a trailer with a 6 inch tall trailer frame you are going to have to use a weld-on bracket part #F500277 as there isn't a bolt-on style bracket that will fit a frame that tall. The weld-on bracket…
view full answer...Hello Nick, thanks for reaching out. The Dutton-Lainson Boat Trailer Jack #DL22335 may work for you. It has 7/16" holes. They are 5-1/2" apart across. There is 2-3/8" between the top hole and the hole under it. Then there is 1"…
view full answer...Hey James, thanks for the information! To replace the inner member of your Dexter actuator we've got a couple of options depending on which one you actually have. The Model A60/A75/XR84 you have stamped on your is three different styles of brake…
view full answer...Hey Tim. There are only two jacks that will fit your current mounting bracket and they are both Fulton F2 jacks rated at 1,600 lbs. I have listed them below: Fulton F2 Swing-Up Trailer Jack, Dual 7" Wheels, Sidewind item #F1413060334 Fulton F2…
view full answer...I was able to verify that the weight capacity for the Aluminum Car Hauler Ramp Set #288-07503 that you referenced is indeed 6,000 pounds (not kilograms) for the pair and 3,000 pounds per panel. The recommended maximum height of 16 inches is simply…
view full answer...Hey Bill, so if it was me I would go with the Dutton Lainson winch part #DL17085 over the Fulton. I really like DL winches because they are well made, very reliable, and made in the USA. Fulton winches aren't terrible but DL winches win if for…
view full answer...As long as your transmission is placed in neutral you will be able to flat tow your 2023 Subaru Crosstrek. To flat tow your Crosstrek you'll need the following parts: Baseplate: Roadmaster Direct-Connect Base Plate Kit #RM-52927-5. Tow Bar:…
view full answer...In your 2015 Acura MDX with a factory-installed 7-way wiring setup the best trailer brake controller to use is the Curt Echo #C51180. You will not have to crawl under the dash to find a connector (there isn't one on this vehicle) since the Echo…
view full answer...If you measure the distance between the mounting holes on the bracket you have on your trailer, and they do not match the mounting holes on your F2 jack you may need to have the old bracket removed and use a mounting bracket like part #F500277 for…
view full answer...Yes. The bolt patterns that were referred to in the videos are actually the same and in reality the .06" is a negligible difference that falls within a reasonable margin of error; I believe that on the #F1413050334 measurements were performed…
view full answer...I went to our warehouse and measured the holes you mentioned you wanted the measurement for on the Lippert 1621 5th Wheel Pin Box, part #LC1387882. The holes measure 3/8 inch diameter. I have also attached a drawing of this pin box with the…
view full answer...