Hello Thomas, thanks for reaching out. Yes, the Progressive Dynamics 2000 Watt Inverter w/ Transfer Switch #PD64FR is a good replacement for your WF-5110R Inverter. Youll want to upgrade the wire gauge from the converter to make sure it can handle…
It is possible to mount the springs on top of the axle which is called "flipping the axle". To accomplish this we normally recommend an over-under conversion however there is not one with square u-bolts available for your square axle.…
Hey Randy! The #DE66AR has 1/2" wheel bolts and the #DE68AR has 5/8" wheel bolts. Are you looking for a complete kit with a specific wheel bolt size? What is your axle capacity? The #DE66AR is also for 7k axles and the #DE68AR is for 8k.
To initially tighten a Dexter Nev-R-Adjust Electric Trailer Brake Assembly, like part #23-468, you need to spin the wheel downwards (when looking at it from the backside) with a brake adjustment spoon #W80630 or flat screwdriver. If you are needing…
Hello Francis. Thanks for sending in the pictures. With the axle being 3" diameter tells me that they are 5,200-7,000 lbs. I have a solution for you, but you probably aren't going to get too excited about it. Your best bet is to replace…
Hey Tyler; looking at your picture there I don't think this will be an easy conversion. You could swap hubs over no problem assuming you had a standard bearing combination. However, it looks like the backing plate on the brakes is welded on. This…
Because the 8-14.5 tire that you've got sits on a 14.5" wheel, so you wouldn't be able to switch tire sizes with anything that we have available without also switching to a new wheel as well. If you've got a 6 on 5-1/2" bolt…
I may have an option for you but mobile home axles are considered a one-time use only product and are not designed to be used on a standard trailer. Therefore, there are no hub conversion kits for them that will allow you to use standard…
The Nylon Bushing #TRBU11561 that you referenced will work great for you. It will give you a single bushing that will match what you have well as it has an inner diameter of 9/16 inch and an outer diameter of 1 inch.
If you use the Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs #HAP-105-205-01 that you referenced you'd end up with a height of 4-7/8 inches between the axle center and the frame of the trailer and 8 inches between the tires…
The spacing is going to depend on the size of your tires, so let's start with that. For a 16 inch wheel/tire combo with an 8 on 6-1/2" bolt pattern the best option is a ST235/80R16 size tire with a load range of G to handle the capacity of…
When using trailer suspension hanger kit #AP216-H238 with spring E5115, #e39SR, the distance from the center of the front hanger to the center of the middle hanger AND the distance from the center of the middle hanger to the center of the rear hanger…
Filters
