Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Curt Echo Brake Controller part #C51180 is a great choice because of its convenient and simple installation. The 7-way connector that you mention part # A10-7084VP pugs into the 4-way connector you purchased part #C56217. The white wire from the…
view full answer...To add a 7-way to your 2018 Volkswagen Tiguan you need to add a 4-way connector #118811 and after adding a 4-way you can convert it to a 7-way with #ETBC7 which is a universal 7-way wiring kit. The 7-way has to have the 4-way to work. I have attached…
view full answer...Speed is a huge issue with trailer tires actually. Unless otherwise noted trailer tires are rated as 65 miles per hour as their max speed. Exceeding the speed rating will cause the tire to heat up and fail easier. We do have a couple brands that have…
view full answer...Hey Wanda, welcome back! The Rear View Safety License Plate Bracket for Backup Camera item #RVS-401 will work great with your WiSight Backup Camera item #ASA57YR. It secures using the top two mounting holes that hold your bracket to your NuCamp…
view full answer...That's a good question, and in order to use the Curt Echo Mobile Trailer Brake Controller #C51180, it requires simply the 12 volt, ground, and turn signals be connected to the 7-way on your truck. So you will need the 12 volt connected that you…
view full answer...The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…
view full answer...The only way to determine which wire is the reverse wire on your RAV4 is to have someone put the vehicle in reverse and for you to test the wires with the Cordless Circuit Tester #PTW2979. While not on a RAV4, I have added a link below to a video…
view full answer...In order to activate the 12V circuit on your truck's 7-Way so that you can maintain the charge on the trailer's auxiliary battery, you just need to run a length of 10 gauge wiring like #10-1-1 (sold by the foot) through a breaker like #9510…
view full answer...Typically the black wire on a trailer 7-Way like the Hopkins #HM20048 is for 12V power. It will run from the positive battery terminal on your tow vehicle back to your trailer battery or whatever you're needing to power (like interior lights).…
view full answer...You are correct. The Curt Easy Mount bracket #C58000 would not allow you to also use an anti-rattle device such as #RM-061 that has to clamp around the hitch receiver. You could go with an alternative anti-rattle device such as #63232. Or a different…
view full answer...Hey Graham! It looks like the Sunseeker is built on the Sprinter 3500 chassis, I recommend verifying that to be sure. For a brake controller I recommend the Redarc Tow-Pro Liberty #RED24FR. This is simple, reliable, and doesn't take up any space…
view full answer...It could need a fuse, less likely that it would need a relay but you can check the fuse panel lids to determine if there is one that is missing for brake controllers, tow package wiring, CHMSL, or stop light. If that is not the issue then you would…
view full answer...Related Searches