Search: jack foot   >   !Trailer Hitch Ball Mount   >   Automotive Tools   >  

Determining the correct rise or drop for your Blue Ox SwayPro Weight Distribution System #BXW1000 is going to be the same method as determining rise or drop for a standard ball mount. You will just need to measure from the ground to the top of your…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

As you can see on the attached photo, the wiring diagram for HydraStar Adapter #HBA-CAM shows there can be a 25-40 amp circuit breaker in-line with the black wiring which goes from the battery's positive terminal to the adapter. I would stick…

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

The prep you mentioned is more than adequate prior to applying the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV. According to the instructions you only need to apply the Primer #AL77CV if you're applying this to an EPDM membrane. In that…

Sorry to hear about the troubles you're having! To remove the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV from the side of your 1998 Tiago, you can use: - A type of chemical paint remover, - A Paint scraper tool, - A Pressure washer, Or…

Slipper Springs like #e33SR do not use a bolt and bushing for the open eye end of the spring. It connects directly to the hanger using a slipper spring hanger kit.

The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…

I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…

As long as you aren't exceeding the speed rating of the tires which would cause them to get to an excessive heat you are fine. Trailer tires are designed to be inflated to their max PSI rating when cold and then the pressure increase from heat…

While we don't have any custom fit trailer wiring harnesses that fit the 2011 Isuzu NPR we can still help with a universal fit option like the #C56175 which you'd have to wire to the taillight circuits of your NPR.

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…