Trailer Wiring Solution for 2011 Isuzu NPR

Question

Question:

I have a 2011isuzu npr and need a trailer light wiring hook-up any help thank you

asked by: Jody

0

Expert Reply:

While we don't have any custom fit trailer wiring harnesses that fit the 2011 Isuzu NPR we can still help with a universal fit option like the # C56175 which you'd have to wire to the taillight circuits of your NPR.

expert reply by: Jameson C

0

Answer 1

Hello John, You are not able to find it, because it is not there to be found on the 2020 Jeep Grand Cherokee. You will need to install the Roadmaster Stop Light Switch Kit #RM-751449. Are you knew to flat towing, or getting a new vehicle set-up?

view full answer...

Answer 2

The Isuzu NPR models are not factory wired for an electric brake controller. If you already have a 4-way trailer connector, then you will use the wiring kit #ETBC7 to hardwire your brake controller. If you already have a 7-way trailer connector, then…

view full answer...

Answer 3

For your Pilot 2-6 Brake Electronic Brake Controller - Time Delayed #80550, you will need to connect the black power wire to the battery of your vehicle using a circuit breaker like #PK54530 and #12-1-1 wire. Then you will connect the red wire on…

view full answer...

Answer 4

Unfortunately I do not have a video of finding the coldside of the stop light switch on your 2020 Jeep Grand Cherokee, so you'll just need to keep testing the wires going to the stop light switch with a circuit tester like #PTW2993 until you find…

view full answer...

Answer 5

Hey Ken, yes the Curt hitch #C67RJ is a fit for your 2024 Toyota Prius Prime XSE. I went over the Curt install instructions for this hitch and there's no mention of any sensors so I would assume it doesn't require any special steps. Curt in…

view full answer...

Answer 6

Hey Joe! Don't worry, this is a pretty common question. When it comes to towing you are always limited by the lowest rated component. Trailer hithes are often capable of handling more than the vehicle they're designed for. Even though a hitch…

view full answer...

Answer 7

Hey Tim! It looks like our fitguide isn't updated to include the Discovery for that wiring harness which is why you aren't seeing it. However, Stealth Hitches has confirmed it fits the factory wiring on the 2017 - 2024 Discovery. You will…

view full answer...

Answer 8

The custom fit kit part #INK642 that you referenced is the correct fit kit for the 2013 Honda Civic Coupe. To complete the roof rack system you will need Inno Aero Crossbars part #INXB130-138 and Inno Through feet part #INXS250. The Inno crossbars…

view full answer...

Answer 9

In order to narrow this down I would start by checking the vehicle side of the connector. Check and see if there is power using a circuit tester like the #PTW2993. If you find that there is power then you can rule out anything on the vehicle side and…

view full answer...

Answer 10

Johnathan, since there there is a signal with the lights off, then there is a problem on the vehicle side. What you're going to need to do is check to make sure that the brown wire is properly connected to the running light wire at the rear of…

view full answer...

Answer 11

The E1 error code on Hopkins brake controllers indicates that a trailer is not connected. If you do not have a trailer connected it will continue to display E1. If this happens when a trailer is connected then that could indicate a problem on the…

view full answer...

Trailer Wiring Solution for 2011 Isuzu NPR

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching