Replacement Hub, Drum and Brake Assemblies for AL KO 3,500 lb Axle
I have a 2008 Flagstaff camper with two Alko axles. It is in need of new brakes/drums. Ive attached a photo of the plate attached to the front axle. Could you reference me to the proper parts, drums and brakes, including seals and dust caps...
Recommended Replacement Hydraulic Pump Motor for a Lippert Leveling System
is the 172911 the replacement for 414850 on a Lippert leveling systems? | Tan, it actually looks like the Replacement Hydraulic Pump Motor for Lippert RV Leveling Systems # LC57AF is the correct replacement for your Lippert 414850. To get...
Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Does The Rampage Rock Rage Bumper Have Add-On D-Rings And What Is Needed To Flat Tow A 1999 Jeep TJ
does this bumper have an option for D-rings? what is required to flat tow my 1999 jeep tj behind my motor home with air brakes? Thanks | The Rampage Rock Rage Front Bumper for Jeep # RA97801 doesn't have a D-ring add-on option so you'd have...
Can A Trailer Wiring Harness Be "Stacked" On A Flat Towing Wiring Harness?
I have a 2000 jeep wrangler with a curt 55363 wire harness for pulling a small trailer. Can I also plug in a curt 58902 harness for flat towing the jeep? Can I just plug in the flat tow harness to the jeep then plug the trailer harness in to...
Troubleshooting Curt Trutrac System Digging Into Brackets
I recently purchased the Curt Trutrac WD C17501 for my 2004 Ford Excursion towing a 39ft travel trailer. The tongue weight loaded is around 1100 lb. The RV dealership installed the weight distribution on my trailer and set it up but after driving...
Replacing A Dometic Penguin II RV Air Conditioning System With An Advent Air RV AC System
The connector on the Advent is a 6 pin which is not used for this Dometic unit. I can cut and use the three wires for incoming AC but how do I connect the CCC2 thermostat to the Advent unit? | Because the control box for your Dometic Penguin...
What Dual Receive do I Need for Flat Towing My Jeep and a Bike Rack with 2 e-bikes?
Hello eTrailer— I’ve got a multi part see * ‘s below question. Hopefully you can offer some insight / suggestions: I’m interested in finding a * ‘high / low’, 2” hitch double 2” female receivers with sufficient weight ratings for setup described...
Is Curt Base Plate Kit for a 2006 Jeep TJ Compatible with a Blue Ox Tow Bar
Curt Custom Base Plate Kit - Removable Arms Item # C32KR I was looking into purchasing this base plate and was wondering if the removable tabs were interchangeable with the blue ox tabs? I currently have a vehicle with the blue ox setup and...
Can The etrailer Classic Base Plate Kit # e74FV Be Bolted To A Rockhard Front Bumper
Will this base plate kit work on Rock Hard or LOD aftermarket steel bumpers installed on a 2004 Jeep Wrangler Unlimited LJ? | Hi David, The etrailer Classic Base Plate Kit # e74FV could be bolted to your Rockhard front bumper but you'd need...
Will Installation of Curt Custom Base Plate Kit on 2003 Jeep TJ Reduce Ground Clearance
Will this base plate kit reduce ground clearance? | Hi Stephen; yes, installation of the Curt Custom Base Plate Kit # C32KR will reduce ground clearance at the front of your Jeep. This hangs down below the bumper as seen in the photo below....
How to Tighten Self Adjusting Brake Assemblies by Hand
For first time set-up I need to move the brake pads out, so what do I do with the metal auto adjust arm, and which way do I turn the star wheel to expand the pads outward? | Hey Brian, if you grab the magnet and move it in the direction of the...
Is There Front Hitch for 2005 Jeep Wrangler that Fits Below Bumper
Do you have a front mount hitch for a 2005 TJ Wrangler that mounts below the bumper AND requires no drilling? | Hey Jim, the only front hitch we have for your 2005 Jeep TJ that installs below the front bumper is the Curt part # C31028 but it...
Recommended Air Bags for a 2005 Ford Econoline 350 w/ a V10
I have a 2005 Ford Econoline 350 with V10. It has a 3 inch lift. Do you have any rear air suspension products that would work with the lift. I want to tow with it and I am a huge fan of of the rear suspension airbag systems. | Hey Russell, we...
Parts Needed to Flat Tow 2002 Jeep Wrangler TJ
Can you refer me to a shop near Seattle or Bellevue area that can do a complete set up of my 2019 Leisure Travel Van Unity to Flat Tow a 2002 Jeep Wrangler TJ model X, including BASE PLATE, WIRING LIGHTS, BRAKING, CHARGING etc. tow bars. I would...
Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
D-Ring Kit for Flat Towing a 1998 Jeep TJ with Roadmaster Falcon All-Terrain Tow Bar
I have everything but a base plates to flat tow my jeep tj 1998. Roadmaster all terrain, cross bar, 1427-1 male, two of them to attached to separate base plates on jeeps frame. I dont see these listed on your site. The part number is 1424-1,...
Base Plate Kit to Use with Blackhawk Tow Bar and 1997 Jeep Wrangler TJ
I have a 97 Jeep TJ that I want to tow behind my motorhome. I have the Blackhawk 2 All Terrain tow bar set up already, but what do I need to install on my jeep to make that work? | Hey Ron, you would just need a Roadmaster base plate kit for...
What is Max Amperage Draw of Bulldog Winch Light Duty On-Board Air Compressor
What is the maximum amp draw of this compressor? | Hey Michael, the Bulldog Winch Light Duty On-Board Air Compressor # BDW46TJ draws at max just under 40 amps. |
What Rack System Can I Use On My 2002 Ford Excursion With Factory Side Tracks
Will this fit the factory tracks of a 2002 ford excursion? | Great question, Dave! After some double checking I can confirm that Rhino Rack part # Y02-480B-NT will work on the factory tracks on the roof of your 2002 Ford Excursion. What are...
Looking For A Shocker Hitch For My 2003 Ford Excursion Pulling A 7k Trailer
I am interested in a shocker hitch. I have a 2003 ford excursion, 7.3 l diesel with 4 wheel drive. I primarily pull a RV that weighs 7,000 lbs. What model do you recommend? thanks | Hey Patrick, The Shocker Hitch # SHK47VR would be a solid...
Looking For Replacement Weather Stripping For Lift Gate On 2003 Ford Excursion
I need to replace the weather stripping for the lift gate on my 2003 Ford Excursion and the OEM Part 2C7Z-78404A06-AA has been discontinued. I have been searching junk yards and the internet for something that might work. Might you have something...
Measuring The Clearance At Back Of 2003 Jeep Wrangler TJ With Spare For Hitch Mount Bike Carrier
I am looking for a 2-bike bike rack for the hitch. This is for a jeep wrangler with a spare on the back. Do you have one with an arm long enough to clear the spare? | I am attaching a helpful article that explains how to measure to see what...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Filter Your Search
Contact and Help