Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
Updated 02/03/2026 | Published 07/05/2024
Question:
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver behind my surge brake module I am aleready at 33 inches....
asked by: Etienne F
0
Coupler Measurement
(click to enlarge)
(click to enlarge)
Expert Reply:
The measurement for the Pole-Tongue Adapter # EQ95-01-5950 to sit 27"-32" is taken from the rear of the coupler ball cavity. This is where the back of the hitch ball will sit in the coupler.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Pole-Tongue Adapter for Equal-i-zer Weight Distribution Systems - 14,000 lbs GTW, 1,400 lbs TW
- Accessories and Parts
- Weight Distribution Hitch
- Adapters
- Pole Tongue Adapters
- Equal-i-zer
- Equal-i-zer
more information >
Continue Researching
- Q&A: Why Are the Spring Bars on My Equal-i-zer Hitch Too Tight to Lift Onto the L-Brackets?
- Q&A: Weight Distribution Hitch for Pole Tongue Boat Trailer
- Q&A: Is There Rear Suspension Enhancement that Fits 2021 Chevy Tahoe
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can a Weight Distribution System be Used on a Boat Trailer
- Q&A: Recommended Equal-I-zer Weight Distribution Hitch for Ice Castle Fish House Trailer
- Q&A: Weight and Sway Distribution Hitch For 2013 Camplite Trailer And Aluminum Frame
- Q&A: Weight Distribution Hitch For Boat Trailer With Pole Tongue
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Tell the Weight Rating of a Trailer Axle
Chris R.
2/3/2026
Hey, did measuring from the rear of the coupler ball cavity clear up the placement for your pole-tongue adapter? Knowing how that worked out could help others trying to get the same setup right.