2019 Airstream Basecamp Travel Trailer RV Camera

Hey Bill, yes the Furrion Vision S+ #FR64AD would be a direct replacement for your current Vision S system. None of it is backwards compatible with the standard Vision S system though.

Hello David, thanks for reaching out. I hate to be the bearer of bad news, but your only option here will be a new camera system. The WVOM541AP is the old generation of Voyager monitor which is now discontinued. Voyager moved to the WiSight 2.0…

Hey Bruce, the Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision #ASA57YR that you referenced does replace the Voyager setup you currently have installed in your 2018 Airstream Bambi. Sealing the base of the camera mount would…

Hey Michael. The backup camera that comes with the Furrion Vision S+ System item #FR57AD has built in mounting holes in the casing. It comes with four #6 x 3/4" flat head self-tapping screws, four #4 x 1/4" self-tapping screws, sealant, and…

Hey Luke! What kind of trailer do you have? Yes, the Furrion Vision S+ Wireless RV Backup System #FR57AD will fit where the old Vision S was. They use the same mounting bracket and wiring so it should be an easy swap. The only thing that isn't…

Hey Alfredo! Great question. The Furrion Vision S+ Wireless RV Observation System #FR57AD, #FR74AD, and #FR64AD are all capable of recording. The 7" monitor has a micro-SD card slot (must be at least Class 10) and supports cards up to 128GB.…

Hello Alberta, thanks for reaching out. I have heard of this happening before with the Voyager monitors where condensation gets inside and fills the camera with water. Sadly there is not a great way to clean this and the camera is most likely done. I…

The Replacement Voyager WiSight 2.0 Wireless RV Backup Camera with Low Light Assist #ASA64YR will only work with the WiSight 2.0 monitors. The new cameras and monitors are not backwards compatible as Voyager no longer produces a camera which is…

Hi Lynda, The distance between the camera and monitor shouldn't be more than 60' for your setup so I would check the voltage getting to your camera. A weak signal is usually a sign that the running light circuit isn't providing enough…

Hey there Michelle! While weight distribution systems are supposed to get the truck and trailer as level as possible, they are not complete miracle workers and won't make both 100% level in all situations. In fact, Andersen has a section of the…

Hey Mike, it is important that you use the included power cable with the Furrion Vision S+ Wireless RV Backup System w/ 1 Camera #FR57AD like the instructions indicate. If this is like a hardwire install I would look for a cigarette lighter to 2-wire…

Thanks so much for the photo, it was super helpful, and what it shows is that your trailer has the Voyager WiSight Pre-Wire Plate. This will allow you to mount the Voyager WiSight camera system: - Voyager WiSight Wireless RV Backup Camera System…