1997 Toyota Previa Radiator Fan

Since your 2024 Toyota Grand Highlander doesn't come with the factory tow package you need the Curt T-Connector Vehicle Wiring Harness #C79VV. The module plugs…

I do have an option for you but we do not carry the exact replacement you are looking for. For your trailer, I recommend using the Dexter Equalizers part #13-140-3. These equalizers are almost an exact replacement for the ones you currently have.…

You'll need to do some slight measuring to ensure the fit of the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV on your 4WD 2022 Ford F-350…

I do have an option for you but Atwood was bought out and their replacement parts are no longer available, including the repair kit you would need. The best option is to replace that A-frame coupler with a new one that attaches to a 2 inch hitch…

The standard measurement on landing gear legs is 15-1/2 inches between the tabs that are on the actual legs. Despite the 15 inch measurement you have between the brackets the distance is likely 15-1/2 inches between the tabs on the leg. Replacement…

Yes, the 16K 5th Airborne Premium 5th Wheel Air Ride King Pin with Sidewinder #5AS16K will be perfect for your 14K 2023 Keystone Cougar 368MBI. Please note you also need the rotating turret part RP61300. This is currently unavailable so…

Electric fans do improve fuel mileage and power since they allow the accessory belt drive to turn with less resistance. I did the same conversion on an older Camaro years ago and it cooled better, improved mileage, and power.…

Yes, the Curt Trailer Hitch Receiver #13707 is a confirmed fit for both a 2003 Mercury Grand Marquis and a 2007 Lincoln Town Car. The replacement hardware can be found with part #RHK. You will simply click on the linked part and then select…

For your 2003 Ford Crown Victoria you can use Hopkins trailer wiring harness #46255. There isn't a T-connector that just plugs into the taillight wiring available…

With just the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118540 installed not connected to a trailer there would not way it would just put an amperage draw on the electrical system. Current has to go somewhere to draw from the…

Is the fan set up currently on your 2008 Chrysler Aspen belt driven? In any event you will need to determine if it is pushing air or pulling air. The fans that you have referenced, #D16927, and #D16919 are for puller applications only. What I…

When installing The Hopkins 7-Way Molded Trailer Wire Connector #HM20048 on your 1984 Chevrolet C/K Series Pickup the black 12 Volt hot lead will have to be used in order for the brakes to work. I have attached the wiring code below: White Wire -…