Where is the Grommet in a 2011 Toyota RAV4 Used for Routing Power Wire to Vehicle Battery
Updated 11/24/2014 | Published 11/22/2014 >
Question:
Cant seem to find small gromit for exiting rear compartment with black wire to be run all the way to the battery. Shown about 5 minutes into installation video. Also where would the flat connector and trailer wiring exit for fastening to provided fixture hose clamped to hitch?
asked by: Ron E
Expert Reply:
I attached a picture that I took from the install video you referenced (also attached), that shows where the rubber grommet will be located in the compartment of your 2011 Toyota RAV4. It's hard to see in the video, but its at the very bottom of the compartment.
When not in use the harness will store in the interior of your vehicle, and then when towing you would just need to pull the 4-way out of the hatch, connect it to your vehicle, and then shut the hatch on the wiring. The soft weather stripping won't damage the wiring.
I also attached an FAQ on routing the power wire for trailer harnesses like yours.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Q&A: Best 2010 Toyota RAV4 Sport Hitch for Ground Clearance
- Video: Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C56165 Review
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Shop: Brake Controller
- Q&A: What are Differences Between Curt and Tekonsha Harnesses?
- Q&A: Will the Curt Replacement OEM USCAR Trailer Connector Fit in the Same Spot as the Factory 7-Way?
- Shop: 7-Way RV Upgrade Kit for Trailer Brake Controller Installation - 12 Gauge Wires
- Shop: Curt Replacement OEM USCAR Trailer Connector - Dual Connection - 7-Way RV Style and 4-Way Flat
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: Possible Replacement for Trostel 300-156-6 Seal
- Q&A: Brake Controller Install on 2007 Jeep Commander with Factory Tow Package
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne




