Depth of the Redline Garnish part # 2756

Question

Question:

Is it deep enough for 1/2 for pop rivets/gasket to be concealed?

asked by: Sheri

0

Expert Reply:

The leg length or the depth that the garnish part # 2756 has is right at 2 inches. From the picture you submitted it looks like you installed the roof vent part # 9106 with the mounting flange on the inside of the trailer. The vent should be installed with the mounting flange on the outside of the trailer and then use the garnish to cover up the opening you cut.

In that configuration the garnish would conceal the hole you cut and the rivets. It can also be trimmed shorter if needed.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I reached out to my contact at Jensen and he did say that your AWM975 model stereo has been out of production for a while. To replace the unit he said the best option is with the Jensen RV Stereo #JWM60A, which features the same cutout size and…

view full answer...

Answer 2

For a general-purpose safety chain for a standard gooseneck trailer we offer #337BSC3842 from Buyers Products. This is a 42-inch chain with 3/8-inch clevis. The chain is rated for 15,000 pounds. This is sold as a single chain, not a pair. The 36-inch…

view full answer...

Answer 3

To measure for safety chains you will want to have the trailer hooked up to your tow vehicle with it just about jack knifed as this is the furthest the safety chains will be stretched. You will measure from one side of the tongue where you will be…

view full answer...

Answer 4

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Depth of the Redline Garnish part # 2756

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching