Waterproofing Trailer Taillight Assembly Connections on a Boat Trailer
Published 08/11/2014
Products Featured in This Question
Question:
i ordered and received. my Nitro trailer has a black 3 wire conector in a trangular shape. Are these connector availble ?
asked by: Tim D
Expert Reply:
What you can do is apply something like Liquid Electrical Tape, # SWC50122, which will insulate, seal, and waterproof electrical connections. I would still recommend wrapping any connections with actual electrical tape as well for extra protection.
Another option is to use heat shrink tubing which is usually available just about anywhere tools and/or automotive parts are sold. With this you would first place the tubing around one of the wires before making the connection. Then use a butt connector to connect the wires. Slide the heat shrink tube over the connection and apply heat as per the directions. This will create a water tight seal as well. And I would still wrap that in electrical tape, too.
I still would recommend you disconnect your trailer connector prior to backing the trailer into water.
Product Page this Question was Asked From
LED Tail Light for Trailers Over 80" Wide - 8 Function - Submersible - 23 Diodes - Driver Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop
- Tail
- Turn
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8L x 3W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Shop: RoadMaster 6-Wire Trailer Connector - Vehicle End
- Search Results: dielectric grease
- Search Results: 6 way plug
- Video: 2021 Ford Ranger RoadMaster 6-Wire Trailer Connector: Complete Installation
- Video: Review of the Blue Ox 6-Pole, Round Pin, Trailer Wiring Socket
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Video: Installing the Roadmaster Battery Charge Line Kit for Towed Vehicles on your 2022 Jeep Wrangler
- Video: A Closer Look at the Pollak 6-Pole Round Wiring Socket
- Video: Installing the Pollak 6-Pole Round Wiring Socket on a 2024 GMC Canyon
- Shop: Roadmaster 7-Way Socket
- Q&A: Troubleshooting Recently Replaced Electric Trailer Brake Assemblies That Arent Functioning
- Q&A: Waterproofing Electrical Connections on Optronics Boat Trailer Tail Lights
- Q&A: What is the Difference Between Submersible and Waterproof Trailer Tail Lights
- Q&A: How to Keep Out Water from Electrical Connections on a Tail Light for a Boat Trailer
- Q&A: Spray Lubricant Recommendation for etrailer SD Non-Binding Tow Bar Maintenance
- Q&A: Is Curt 2 to 3 Wire Tail Light Converter Waterproof
- Q&A: Making Electrical Connections for Tail Light Wiring on a Boat Trailer
- Shop: Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Exposed Terminals w/ Rubber Boot - Vehicle End
- Shop: Roadmaster Battery Charge Line Kit for Motorhomes
- Shop: Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Loctite RTV 598 High-Performance Silicone Gasket Maker - Black - 2.7-Fl Oz Tube
- Shop: Liquid Electrical Tape
- Video: A Closer Look at the RoadMaster 6-Wire Trailer Connector