bing tracking image
Q & A Icon

Where to Install the Demco Vacuum Tee Fitting on a 2015 Jeep Wrangler  

Updated 11/18/2026 | Published 11/16/2026

Question:

I bought this for my 2015 jeep jku. It has a sensor on the factory booster elbow. My question is, Where do I install the vacuume check valve on the engine side or do I not need it? I will put one check valve at the demco unit but it’s not clear where or if I need the engine side check valve.

0

Expert Reply:

Welcome back Leigh. You still need the engine side vacuum check valve item # SM99909. You'll install it between the Demco Vacuum Tee Fitting item # DM6257 and the factory vacuum line on your 2015 Wrangler.

You'll need to pull the factory elbow sensor assembly out of the rubber grommet on your brake booster and push the male end of the Demco item # DM6257 vacuum tee directly into that grommet. Then you'll attach a short piece of the provided rubber vacuum hose to the open straight port of the item # DM6257 tee. Then insert the engine side check valve into that short hose with the black side facing toward the engine. You'll then use another short piece of rubber hose and a clamp to connect the factory booster elbow sensor assembly to the engine side of that check valve. You'll then connect your vacuum line from the center barb of the item # DM6257 tee to the second check valve at the Demco operating unit.

Where are you headed on your next trip with the Wrangler once you get your braking system installed? Feel free to answer this and throw in any other questions you have, where it says Add Comment.

expert reply by:
0
Jerred H
DM6257
DM6257
(click to enlarge)
George R. profile picture

George R.

11/18/2026

I installed this piece on my 2021 Jeep Wrangler 392 about two years ago. Knock on wood it has worked with no issues. Love the Demco AirForce One set up vs my old Brake Buddy setup. Way easier!

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>