Recommended Front Hitch for a Ford E-350 w/ a Quigley Conversion

Question

Question:

I’ve been asked to source or build a front hitch for a Ford E-350 super duty van that has a Quigley 4x4 conversion with a 4” lift. Do you offer a front hitch assembly for a Quigley conversion?

asked by: Will

0

Expert Reply:

Sorry Will but we do not. Depending on what year you have we probably don't have a custom fit one for an E-350. I can help you fabricate one with the Curt Weld-On 2" Receiver for Custom Fabricated Hitches item # E17.

I have linked a diagram below so you can see the dimensions of the Curt item # E17.

expert reply by: Jerred H

0

Curt Weld-On 2" Receiver
(click to enlarge)

Will

1/6/2025

Thanks for your reply and the pic with the dimension’s . That definitely helps, and if they like my numbers for fab’in one up. I will deff order from your company. Thanks again Will

Jerred H.

1/6/2025

@Will You're welcome! Happy to help!

Answer 1

Hey Mark, The Go Power Inverter Fuse with Block - Class T - 400 Amp #34243979REVA is typically paired with 4/0 gauge wire. The bare braided wire is typically twisted up and pushed into the ports on either end of the fuse and tightened down with the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hey, Bob! Yes, we do have one! The replacement cable is part #RM-1676-7R. It has the 2 wires that connect directly to tow bar to power LED lights on the sides of the Roadmaster Nighthawk All-Terrain. How long have you been using the Nighthawk?

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hi Steve! What you are looking for is the Roadmaster Base Plate Adapter Brackets for Blue Ox RV-Mounted Tow Bars #RO64FR. These can be used with either Roadmaster's direct-connect or crossbar-style base plates and will also have no problems…

view full answer...

Recommended Front Hitch for a Ford E-350 w/ a Quigley Conversion

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching