Looking for Taskmaster Wheel and Tire in Size 4.80R12 5 Lug Bolt Pattern

Question

Question:

Trying to find this tire on a 5 on 4.5 wheel. Can you help?

asked by: Doyle L

0

Expert Reply:

Hey Doyle, we can help but we don't have a wheel and tire pre-mounted on a wheel with a 5 lug bolt pattern with the Taskmaster tire you are looking for.

So instead you'd want the tire part # TT48012C and have it mounted locally on a wheel like the part # AM20134 which is a galvanized wheel with a 5 lug bolt pattern. What trailer do you have?

expert reply by: Jameson C

0

Answer 1

Hey Coy, You can replace the 8" wheels on your Malone EcoLight Sport Trailer #MAL73FR with ones like the Kenda 4.80-12 Bias Trailer Tire #AM30590. Before doing so you'll want to measure the distance between the tire and fender as well as the…

view full answer...

Answer 2

Hey Giuseppe, The Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel #AM30620 has a max speed rating of 65mph. If you're looking for something with a higher speed rating you could go with the Taskmaster 4.80R12 Radial Trailer Tire w/…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Looking for Taskmaster Wheel and Tire in Size 4.80R12 5 Lug Bolt Pattern

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching