Looking for 110 Volt Outlets for Mini Bus

Question

Question:

Hello, we are looking to install 110 outlets in our mini buses which is not equipped with. Do you have a install kit for it. each bus will have 18 outlets behind pass seats.

asked by: Abdul K

0

Expert Reply:

Hey Abdul, we have 110 outlets like the part # RD26FR which you could use in your mini buses. We even have versions with USB ports like the part # RD59FR if you wanted to give people ability to charge a phone. Do you have a 110 power source figured out for the buses already as well?

expert reply by: Jameson C

0

Kurt K.

9/26/2026

Do you have the 110 outlet with usb ports in brown ?

Jameson C.

9/28/2026

@KurtK we do not. We only have it in white.

Kurt K.

9/28/2026

Ok thanks I gotta have brown Also what wire do you sell for the 110 elect hook up for these boxes I’m buying for added outlets ? I need 20’ of wire as well

Jameson C.

9/28/2026

@KurtK I would go with 12 gauge wire like our part # 12-1-1 that we sell by the foot for a run of wire that long.

Answer 1

The RV Designer outlets like part #RD26FR are 4-1/2 inches long, 2-3/4 inches wide, and 1-1/2 inches deep, measured from the front of the cover plate to the back of the outlet. I’ve also attached some diagrams for reference so you can see all of the…

view full answer...

Answer 2

Rick, you definitely picked one of the nicest RV AC systems out there with the Furrion Chill Cube part #FR49TD. I completely understand wanting to know how involved the install will be before diving into it because nobody wants to get halfway through…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 7

Hey, Greg! There Isn't a way for us to know how much wallpaper you are going to need to cover your Livin Lite 11FDB travel trailer. We can find general interior dimensions but no way to know based off that how much you need to order. Trailer…

view full answer...

Looking for 110 Volt Outlets for Mini Bus

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching