Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery

Question

Question:

Looking for a replacement Breakaway battery.. Old Battery Break Way Corp 081020FHon battery HX-12-5 12V 5A

asked by: Roger H

0

Expert Reply:

Hey Roger, I was able to pull up the dimensions of the battery you have now and found that the Bright Way replacement battery part # 3801250 is exact same dimensions and is also a 5 amp hour battery so it would work great for you.

expert reply by: Jameson C

0

Roger H.

7/20/2026

Thanks for the quick response..Will be ordering one

Jameson C.

7/20/2026

@RogerH glad to help!!

Answer 1

Hey Dakota, the Fulton Square Drop Leg for Stabilizer Jack #FSJ40324 that you referenced is rated individually at 3,000 lbs. So if you were using two it would have a capacity of 6k but you would also need the outer tube part #FSJ10300 as well to…

view full answer...

Answer 2

Assuming that when you tested the resistance of the brakes you were testing the two wires on each magnet and getting 2.0 and 2.8 ohms the magnets on your trailer are not working correctly and will need to be replaced. For 7" brakes you should…

view full answer...

Answer 3

Hi Ron! To get the 12v power port on your 7-Way working, you will want 12 gauge wire and a 40 amp circuit breaker (I have both listed below). This will get you needed power and protection for your Curt Echo Wireless Brake Controller #C51180. 12 Gauge…

view full answer...

Answer 4

While we don't have replacement parts for a Model 70LP actuator, we do have a great replacement for it. Like the 70LP, these actuators are a fit for a 2" hitch ball, but they just have a slightly larger capacity at 7,500 lbs. You didn't…

view full answer...

Answer 5

Hey Jeff, we can definitely help but the pins that go into the breakaway switch are not all universal and unless you know what brand it is the best solution is to just replace the entire switch like with the part #420000 as this approach is universal…

view full answer...

Answer 6

The grease seal you need is the part #13194 which has an inner diameter of 1.372 inch and an outer diameter of 1.983 inch.

view full answer...

Answer 7

I recommend replacing your axle with one that is more universally compatible. This will help you in the future with sourcing replacement parts when they need replaced. With the bearing sizes on your tapered spindle we do not have a replacement hub.…

view full answer...

Answer 8

We've got the exact replacement breakaway system battery you're looking for. You'll need the Hopkins #HM20008. As you can see in the provided photo, the #HM20008 is a direct replacement.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Roger, I was able to pull up the dimensions of the battery you have now and found that the Bright Way replacement battery part #3801250 is exact same dimensions and is also a 5 amp hour battery so it would work great for you.

view full answer...

Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery

Product Page this Question was Asked From

Continue Researching