Best Front Hitch For 2022 Ram 2500 Power Wagon

Question

Question:

Hi, Does the front receiver hitch work on a 2022 Ram Power Wagon 2500 ? The Power Wagon has plastic brush plates in front as stock so I’m not sure these will work?

asked by: John C

0

Expert Reply:

Hey John, thanks for reaching out. We do have a front hitch for the 2022 Ram 2500 Power Wagon, but the EcoHitch # EH37FR you mentioned will not fit the power wagon models. What you will need instead is the following:

- Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" # C73ZV

This is the only front hitch we offer that fits the power wagon model. We've had several customers buy one and report back to us it does fit the power wagon. I checked with Curt and they confirm this as well. Some bumper fascia trimming will be required though.

What will you be using the front hitch for?

expert reply by: Jesse M

0

Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
(click to enlarge)

John C.

7/1/2026

Thanks! It’ll be used to haul a couple of ebikes. They’re too heavy to go on the back of our camper. Thanks again! John

Jesse M.

7/1/2026

@JohnC Ok awesome! It has a 500 lb tongue weight rating, so that'll be more than enough for a few bikes.

Neal

7/2/2026

@JesseM @Johnc I have a 2022 Ram Power Wagon with the factory winch. I ordered the # C73ZV for my truck. With the winch on the truck, I had to modify the hitch. I had to cut front bolt holes off in a quarter circle pattern to get it tight under front bumper. I did have to trim the front air dam. I now only have 4 bolts holding hitch on truck. That said, the hitch holds a surf rod rack and a cooler, never more than 75lbs at most. Not sure if 4 bolts would hold E bikes.

Jesse M.

7/2/2026

@Neal Ok gotcha. Good to know! Yea with only 4 bolt in, I'd definitely be careful about the weight. For a rod holder you should be fine though. Unless you hook a real monster lol

See All (4) Replies to John C. ∨

Answer 1

Hey Shawn, thanks for reaching out. Yes, the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR will indeed fit your 2025 Ram 2500 with the 6.4L gas engine. It'll be a no-drill bolt-on fit, but some trimming of the front air dam and…

view full answer...

Answer 2

The placement of the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR will not restrict air flow into your intercooler or void your warranty on your 2022 Ram 3500. The area the receiver mounts is also the same area the front license plate…

view full answer...

Answer 3

Hey Chris, Our Fitguide can be a bit confusing sometimes. Essentially the whole category is broken down into whether they fit diesel or non-diesel models. Since the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR fits both gas and diesel…

view full answer...

Answer 4

Hey Jack. The only front hitch that fits the 2025 Ram 2500 Laramie with a diesel engine is going to be the EcoHitch item #EH37FR. This front hitch is designed a little differently so it's compatible with the diesel and gas engine models. It sits…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...