Looking For Rear Suspension Enhancement For 2026 Toyota Sienna LE AWD

Question

Question:

Hello! I have a 2026 Toyota Sienna LE AWD and I am looking to get some help with the rear end sagging under load. I am looking at the spring helpers. Just wondering if the Sumo Springs or Timbrens have any major differences? Which sumo springs would I need for the All Wheel Drive Sienna? It only shows “2 wheel drive” configurations. I just have a vertical hanging bike rack on there Thule Revert 6 bike and the hitch is an eco hitch by Torklift. The rear sags a bit and rides a little harsh so I’d like to get some help there and these spring helpers seem to be the ticket for my application. Thanks in advance. Let me know what you think and I’ll order a set right away. Also, I am a firefighter here in Calgary, Alberta, Canada. Just curious if you offer any first responder discounts on your products. No worries if you don’t, I just figured I’d check. Thanks!

asked by: Braden B

0

Expert Reply:

Hey Braden, thanks for reaching out. Sounds like you are on the right track here. The Timbren/SumoSpring coil helpers will definitely help support the rear end of your Sienna. They beef up the rear coil springs, so you'll see reduced sagging and increased stability.

That said, there really aren't any noteworthy differences between the Sumo and Timbren versions. They are very much just different manufacturers versions of the same product. If I were you, I'd go with the Timbrens # T58GR just because they cost a bit less. The AWD doesn't really matter, as long as the vehicle has rear coil springs, they will fit and work just fine. They are really easy to install too. With 6 bikes on the back, I'm sure that setup will benefit from some enhanced rear suspension.

Also, I'm sorry to say we don't offer any kind of first responder discounts. I definitely appreciate what you do though.

What kind of bikes do you carry? Are there a lot of good trails in your area?

expert reply by: Jesse M

0

Timbren Suspension Enhancement System - Coil Spring Suspension - Rear Axle
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Good morning to you as well Steve, and congrats on your new van! I would be more than happy to make a recommendation for you! The best hitch for your 2026 Toyota Sienna, is going to be our etrailer item #e56RR. This is a class III hitch with a…

view full answer...

Answer 9

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 10

Hey Ben! The Curt does have that restriction on the vertical bike racks so I recommend the TowSmart Trailer Hitch #TS82VR. This has a higher tongue weight capacity and will allow you to carry the VelociRAX. It would be a good idea to add the etrailer…

view full answer...

Answer 11

The best hitch for a 2024 Toyota Sienna is the Curt item #C22UR. This hitch is custom fit and bolts to your Toyota with included hardware. It is a class III hitch with a 2" receiver that has a 3,500 lbs towing capacity and a 350 lbs maximum…

view full answer...

Answer 12

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Looking For Rear Suspension Enhancement For 2026 Toyota Sienna LE AWD

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching