Wiring Needed to Wire Up Utility Trailer
Updated 06/15/2026 | Published 06/08/2026
Products Featured in This Question
Question:
I am restoring a 2008 16’ Corn Pro utility trailer. I would like to replace all the wiring. What wiring kits would you recommend for this project? Thanks
asked by: Joe B
Expert Reply:
Hey Joe, a great place to start would be the etrailer junction box part # e99011. Installing this up front on the trailer gives you a good place to then run all of the circuits too for the trailer lights and brakes etc. You can also use jacketed wire like part # DW04906-1 that we sell by the foot if you want to carry more circuits back to the rear of the trailer in one bundle but generally you'd just run each circuit individually to the junction box. Be sure to use 10 gauge wire like part # 10-1-1 for the ground and brake output, and 12 volt accessory circuit.
Brian
6/12/2026
Purchased the trailer wiring 7-way upgrade lot w jumction box. junction box fit perfectly on tongue of flatbed trailer making for easy wiring and connection of plug.
Jameson C.
6/15/2026
Product Page this Question was Asked From
etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug and Lead
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Recommended Electric Over Hydraulic Conversion Kit for a Boat Trailer w/ 3,500 lbs Axles
- Q&A: Disc Brake Kit Recommendation for 2022 Grand Design Reflection 337RLS
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Where to Mount the 6-Way Bracket on the etrailer Invisible Base Plate Kit e44FV
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: How to Add Timbren Axleless Suspenion to a Trailer and Use 5 x 5 Lug Jeep Wheels
Harry A.
6/10/2026
I purchased the 7-way trailer wiring for my fifth wheel camper. I found this kit to be of good quality, and has held up well so far, and I am pleased with the product.