Air Spring 1000 Helper Springs for 2021 Ram 1500 Warlock

Question

Question:

Does this fit a 2021 ram 1500 warlock?

asked by: Lorne M

0

Expert Reply:

Hello Lorne!

For your 2021 Ram 1500 Warlock you'll actually need the Air Spring 1000 part # AL60828HD. This is the same model as the one you were looking at but this one is specifically designed for your Ram 1500 Warlock.

The kit you mentioned is designed to fit older models of the standard Ram 1500 along with new models of the "Classic" edition.

This will give you everything you need for install and use and will work wonders to lift up the rear of your truck when you're hauling or towing. I attached an install video too that you can follow along with if you plan to do it yourself.

What types of gear do you plan on hauling in the truck? Any fun plans for the summer?

expert reply by: Chris R

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 3

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Mike, welcome back! Thanks for all of the info you listed from your Grand Design. Based on that and fact you have 5,200 lb axles the correct bearing kit would be the part #BK3-300 which comes with the correct bearings, races, seal, and a cotter…

view full answer...

Answer 9

Hey Steve, thanks for reaching out. You can indeed use the Weigh Safe Ball Mount w/ Built-In Scale #WS56KR as a tongue weight scale, then go back to your Equalizer hitch for actual towing. That's a pretty good idea honestly, as long as your…

view full answer...

Answer 10

Hey Derek, great question and thanks for stopping by! So mainly between the yellow #SSR-127-54 and the black #SSR-127-47 SumoSpring Solo's is the capacity. The yellow's are going to be for a heavier load application with a 2,800 lb capacity,…

view full answer...

Air Spring 1000 Helper Springs for 2021 Ram 1500 Warlock

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching