How Is Install Hardware Mounts for Optibrite LED Light Accessed
Updated 05/19/2026 | Published 05/17/2026
Question:
Part Number OPT32ER Hi, so how this porch Led is morning? I see the two holes on the led housing, but how you access the holes? It have to be from the outside somehow. Thanks
asked by: Adrian M
Helpful Expert Reply:
Hey Adrian, you would need to remove the plastic cover from the front of the Opti Brite LED strip part # OPT32ER which will reveal the mounting holes underneath that you would run hardware through and then once you do that you'd put the cover back on the light. I attached a picture that shows the cover removed for you to check out.
(click to enlarge)
Cathy
5/19/2026
Ditto what Jameson C said. Install was about 15 minutes from start to finish.
Jameson C.
5/19/2026
Product Page this Question was Asked From
Opti-Brite LED Strip Light for RV Awnings - Weatherproof - Black Housing - 11" Long
- Accessories and Parts
- RV Awnings
- Lights
- Strip Light
- Black
- Optronics
more information >
Continue Researching
- Q&A: Replacement Lights for RV With Lights Taking Water Damage
- Q&A: Is There a Replacement Inner Arm for a Solera Awning V000564552
- Q&A: Replacement Gearbox for Solera Manual Crank Style Awning Drive Head LC300031
- Q&A: Replacement Parts For Lippert 7,000LB Trailer Axle On Kaufman Trailer
- Q&A: Installing Brake Controller on 2010 Ford E450 Class C Motorhome
- Q&A: Length of Bolts in Demco Hardware Kit 6166
- Q&A: Replacement Wall Control Remote For MaxxAir Vent Fan 4951
- Article: Trailer Lighting Requirements
- Article: Ram Trailer Tow Prep Package
- Article: How to Choose the Right Trailer Hitch Class
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
George
5/19/2026
Was very easy didn’t take that long to put new one on