Can The etrailer Hitch e62AR Be Installed On A 2018 Cadillac XT5 Platinum?  

My 2018 XT5 wore this very same hitch for years before a drunk driver totaled her. Special notes not mentioned: a) I thought that stainless steel beauty strip wasn’t beautiful enough reapply my original, which IF one is exceedingly careful the original could be reaffixed. The s/s strip is held on by many delicate “butterfly fasteners”. A few of these are going to be destroyed but it would be held in place with a few missing. I left mine off and never missed it. b) I’m not obsessive enough to care of strangers noted my receiver. He’s right, that plastic cover will be a constant pain to remove/replace. I bet one could remove n replace the original. c) NOT MENTIONED IS THE REQUIRED stop at U-Hall to buy a actual electrical connection for your trailer’s lights. If you look underneath the car where the original Trailer Light Receiver SHOULD be there is just a stupid stub of wax(?) where all other models have a Trailer Lights Receiver is. d) MOST IMPORTANT TIP IS TO PULL THE CURLY Q THINGY MUST BE, MUST BE STARTED AT THE MOST FORWARD HOLE ON EACH SIDE FIRST, repeat start pulling the curly Q spring tool from the most forward hole first!!! I wrongly thought I will start at the most rear bolt first you know, to get used used to this strange process of threading the bolt’s threads into the curly Q “tool”. The driver side three bolts took almost two hours and my entire vocabulary of sailor swear words. The passenger get side took 12 minutes. A word from the deeply scared experienced one.