Does etrailer Brand Awning Fabric Have Integrated LED Light Strip Channel

Question

Question:

Can I use my integrated led light track on this replacement awning fabric?

asked by: Leo P

0

Expert Reply:

Hey Leo, yes the etrailer replacement awning fabric part # e86QV does have ability to have a light strip integrated into it. Do you have an etrailer awning currently?

expert reply by: Jameson C

0

Answer 1

Hey Kevin. Our Replacement Fabric for etrailer Powered RV Awning item #e86QV is just the replacement fabric. It'll attach to your existing awning roller so long as you have a 20' powered awning. There is no stitching built into the fabric for…

view full answer...

Answer 2

Hey Jean-Marc, so the part #LC423331 was designed to be trimmed and has edges that were designed to be trimmed at so you don't have to reseal anything. Yes the LED Light Kit w/ Switch for Solera RV Awnings with Prepflex Fabric #LC674283 does come…

view full answer...

Answer 3

I spoke to Lippert and they told me that the LED Fabric Light Kit #LC674283 has a waterproof rating of IP55 but they don't have a Lumens rating for it. The best they could offer was the CCT which is 6000K. I attached a picture that shows how well…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Does etrailer Brand Awning Fabric Have Integrated LED Light Strip Channel

Product Page this Question was Asked From

Continue Researching