Looking for 17-1/2 inch Diameter Wheel with 8 Lug Bolt Pattern 9/16" Stud Size
Updated 04/09/2026 | Published 04/08/2026
Products Featured in This Question
Question:
Need to replace the following Wheel: Lynx Silver Aluminum Wheel 17.5 x 6.75 865 - 9/16-18 Lug nuts. U/etrailer has Part LI44FR, which looks like the wheel I need, BUT uses 5/8 . Does this wheel come in 9/16 Lug nut, if so, can it be ordered?
asked by: William H
Expert Reply:
Hey William, I wish we could help but we don't have a version of that wheel that has the correct wheel stud size that you need. We don't have a whole lot of options that would match what you need but we do have the part # LH88VR which does match the wheel stud size you need of 9/16 inch and is also 17-1/2 inch with an 8 on 6-1/2 inch bolt pattern.
Product Page this Question was Asked From
Aluminum Lynx Trailer Wheel - 17-1/2" x 6-3/4" Rim - 8 on 6-1/2 - Silver
- Trailer Tires and Wheels
- Wheel Only
- 17-1/2 Inch
- 8 on 6-1/2 Inch
- Aluminum Wheels
- Lionshead
more information >
Continue Researching
- Q&A: 17-1/2" Replacement Wheels for 2007 Teton 5th Wheel With 215/75R17.5 Tires
- Q&A: Availability of Black Lionshead Lynx 17.5 Wheel
- Q&A: How Does The Americana Aluminum Trailer Wheel AM63FV Compare To A Sendel T03 Wheel?
- Q&A: Recommended Heavy Duty 17.5 Trailer Wheels And Tires For 16000lb Trailer
- Q&A: Looking for Replacement Wheel for 24 ft Brinkely Z Series
- Q&A: Does the Aluminum Trinity Series Trailer Wheel TA24XR Have Offset?
- Q&A: 2018 Bighorn 5th Wheel Trailer Receiver Hitch Recomendation
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure a Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Tire Sizing
- Article: How to Determine Tire/Wheel Diameter
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Facts About RV Antifreeze Every RVer Should Know
Itoldtimer
4/9/2026
William, The Lynx wheel I bought from etrailer.com was to replace one of my damaged OEM wheels. It was a close match but not exactly. For my rig, I had to take the wheel to a local machine shop and have the center bored out to fit my spindle cone. I also had to have a machined groove on the inside of the wheel to accommodate the spindle cone since the inside of the wheel comes flat. It cost me an extra $100 for the machining. It would be prudent to take all the measurements of the wheel and try to get as close a match as possible. Lug stud size is one of the critical measurements that you may not want to tamper with. In my case, the machining caused no structural issues with the wheel.