Can Spacers Be Added to Timbren SES To Make Smaller Gap

Question

Question:

Can you use the Timbren spacer kit if you want a smaller gap between the SES and the leaf spring?

asked by: Ed L

0

Expert Reply:

Hey Ed! Yes, if you want the Timbren SES # TTORTUN4L to have a smaller gap and engage sooner, or be engaged all the time, you can add the Spacer Kit for Timbren Suspension Enhancement System # T93AV.

Is this for hauling your commercial mower and utility trailer?

expert reply by: Robin H

0

Spacer Kit
(click to enlarge)

Ed L.

3/6/2026

YES,it’s due to the trailer and mower.

Robin H.

3/6/2026

@EdL of course, silly question! It was quite early when I answered this and I got to your other comment right after.

Mike

3/8/2026

I put this kit on a 2019 Nissan Frontier. Installation took about an hour. It has greatly improved the truck's overall towing ability. The back of the vehicle does not drop much at all, and even with a 5,000 pound load connected to the hitch. I could drive 20 miles per hour faster it I wanted to, because the front tires have better contact with the road due to the package. Without a trailer or a load in the bed, the rear suspension is tighter, but not rough riding. I'm happy with the purchase. I added better shocks and brakes to the truck, too, but this kit made the most improvement overall with my towing and carrying extra weight.

Answer 1

Hey Ben, the total height of the etrailer jack part #e34RV when fully retracted is 16-1/2 inches. Would that fit in the area you have between the fender and rear supports?

view full answer...

Answer 2

Hello again Ed! You probably ended up outside our fitguide with some of the Timbren the parts you were looking at. The Timbren SES severe service kit is designed for constant loads like a truck bed camper or salt spreader. Regardless, a severe…

view full answer...

Answer 3

Hi Mustafa; SuperSprings does not offer additional spacers for the SumoSprings. You might be able to get them to send you one if you ask but it will also require a longer bolt. The Timbren SES #TTORTUN4 is the better solution for lifted applications…

view full answer...

Answer 4

Hey Jim, thanks for reaching out. The swivel mount that comes with the #e34RV jack uses M12 bolts. I grabbed one of the mounts from our warehouse to check, and it looks like it comes with M12 bolts, nuts and lock washers, so you shouldn't need to…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Can Spacers Be Added to Timbren SES To Make Smaller Gap

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching