Will DeeMax Adapter Port # DE73MR Fit to 3/16 inch Brake Line

Question

Question:

Will my 3/16 brake line connect directly to this fitting?

asked by: Mason

0

Expert Reply:

Hey Mason, yes your 3/16 inch brake line will connect to the Replacement Adapter Port for DeeMaxx Disc Brake Calipers # DE73MR as that is the size brake line it was designed to fit. Did you lose one off your DeeMaxx caliper?

expert reply by: Jameson C

0

Mason

3/4/2026

No sir I was just making sure they were the same.

Jameson C.

3/4/2026

@Mason Right on!

Pete.p

3/5/2026

Hi Mason, I rebuilt the brakes on my tandem axle pontoon trailer, including some of the brake hoses. I was very pleased the fitment of all of the parts. The adapter ports were spot on.

Answer 1

Hey Ray, sorry about that! The pictures and video are correct for the DeeMax Brake Line part #DE99NR. IT's basically a 90 degree male on one side and a straight male on the other side. I will send an update to have the title fixed thanks!

view full answer...

Answer 2

Hey Mason, yes the Replacement Adapter Port for DeeMaxx Disc Brake Calipers #DE73MR that you referenced is an exact replacement for the port that was on your DeeMax caliper. Did you lose yours?

view full answer...

Answer 3

The Adapter Port #DE73MR you found is an exact replacement for the one on the Caliper #DE86VR. This is designed to accept a brake line like the Kodiak #bh-3mfs90ff-1-5 and not a banjo type connection. You are going to have to alter your brake lines…

view full answer...

Answer 4

It should, Gene. The DeeMaxx Hydraulic Brake Line Kit #DE37SR is designed for triple axle trailers, and will work great with with disc and drum brakes. You're just going to need to make sure the fitting sizes are the right size. This kit uses…

view full answer...

Answer 5

For the DeeMaxx Disc Brake Kit #DE22FR you will need to remove the Adapter Port #DE73MR and clean off the thread sealant. Then you will be able to apply new sealant when you position the port back on in the orientation you need.

view full answer...

Answer 6

You only want to use a thread sealant like the Permatex 59214 on the NPT side of the Adapter Port #DE73MR where it attaches to the Caliper #DE86VR. This sealant is safe to use on brake components since they reach such high temperatures. Be sure not…

view full answer...

Answer 7

Here are the brake bleeding instructions directly from the manual for the Hydrastar Actuator #HBA16. This process needs to be followed to ensure you do not damage the actuator. BLEEDING AND ADJUSTING THE BRAKES 1. It typically is much easier to bleed…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Will DeeMax Adapter Port # DE73MR Fit to 3/16 inch Brake Line

Product Page this Question was Asked From

Continue Researching