Search: disc brakes trailer brakes   >  

Hello Josh. It is possible to convert your Lippert 4,400 lb axles over to disc brakes. The 4,400 lb axles generally use the same braking system as a 3,500 lb axle. These assemblies use bearing #L68149 and #L44649 so you will want to confirm the fit…

Hey Adam, We can definitely get you set up to convert your 2011 Keystone Montana 346LBQ 5th wheel trailer from drum to disc brakes. You'll need a hub and rotor kit, and since you have 6,000 lb axles, what you'll need is the following: -…

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

Dexter organizes their pads by axle capacity. The Replacement Saltwater Rated Disc Brake Pads for Dexter Brake Calipers item #DX72KR fits 3,500 lbs to 6,000 lbs capacity axles.

The DeeMaxx Disc Brake Kit #DE28YR does not have the E-Z grease fitting, you'd want to take a look at the Kodiak Disc Brakes #KOD69FR instead. This brake assembly is the same thing as #DE28YR but also includes 2 hub-rotor assemblies with…

Yes we do have a version of the Hydrastar Disc Brake Kit w/ Actuator for Triple Axle Trailers #HSE7K-TR1 that has 9/16 inch diameter wheel studs with the part #HYD54FR.

Yes, the Hydrastar Disc Brake Kit w/ Actuator for Triple Axle Trailers #HSE7K-TR1SO will fit over hubs with an 8 on 6-1/2 bolt pattern on your 7k Lippert axles. If you don't already have idler hubs you can use the #AKIHUB-865-7-2-EZ-K. The other…

I understand why it would seem confusing running the steel and rubber lines for disc brakes on your trailer that come in a disc brake kit like part #HSE7K-TR1. The steel lines are the main lines on the trailer and the rubber lines extend to the brake…

The difference between these two kits is that the #HSE7K-TR1 comes with a complete hub and rotor that replaces your existing hub, where the #HSE7K-TR1SO is only the rotor which slips over your existing hubs. The hub that is included with the…

Yes we actually installed the Torsion Demco Brake Line Kit part #DM5425 on a leaf spring trailer like what you asked about. You can see how we did it in the attach picture. I attached an install video for this for you to check out as well.

The recommended clearance with leaf spring suspension on an unloaded trailer is between 2 - 2-1/2 inches. You should have sufficient clearance with your loaded trailer, as leaf springs only tend to deflect 1-1/2 inch when carrying a load.

The Curt Combo Bar with 2" Trailer Hitch Receiver #C49360 is made of solid raw steel. It is made in the USA and this unit is equipped with a 1/2" reinforcing collar for extra strength and has a raw finish to be ready for welding. The…