Can Caliber EdgeGlide Be Used Between Ramp Door and Trailer Floor
Updated 12/28/2025 | Published 12/19/2025
Products Featured in This Question
Question:
Can two of these pieces be used on the outer edge of a ramp and the other two piece be used on the inner hinge edge?
asked by: Cyndi
0
Expert Reply:
Hey Cyndi! Are you asking if you can use the Caliber EdgeGlide 2.0 Transition Plate for Enclosed Trailers # CA47EJ between the door and the floor of the trailer? You certainly can! Both of those locations are acceptable for installation/use. I attached some photos below showing the transition plate installed at either end of the ramp door.
Are you using these for a snowmobile or something else?
expert reply by:
Robin H
0
Caliber EdgeGlide 2.0
(click to enlarge)
(click to enlarge)
Caliber EdgeGlide 2.0
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Caliber EdgeGlide XL Transition Plates for Enclosed Trailers - 96" Long - Qty 4
- Snowmobile Trailer Parts
- Transition Plates
- 96 Inch Long
- Caliber
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Caliber EdgeGlide XL Transition Plates for Enclosed Trailers - 96" Long - Qty 4
- Search Results: transition
- Search Results: transition plates
- Q&A: How Much Do the Caliber Edge Glide XL Transition Plates Weigh?
- Shop: Caliber EdgeGlide XL Transition Plates for Enclosed Trailers - 72" Long -
- Shop: etrailer Enclosed Trailer Transition Plate - Universal - 1,000 lbs - Qty 1
- Shop: etrailer Enclosed Trailer Transition Plate - Universal - 1,000 lbs - Qty 2
- Shop: Enclosed Trailer Transition Plate - 81-3/4" Long - Aluminum - Qty 1
- Video: etrailer Enclosed Trailer Transition Plate Installation
- Shop: 6" Wide Continuous Hinge - 6' Long - 1/2" Pin Diameter - Steel
- Q&A: Transition Plates For Trailer Ramp Door That Is 80-1/2" Wide
- Q&A: Are Replacement Universal Axle Bracket for Firestone Ride-Rite Air Springs F22VV Sold Individually?
- Q&A: Looking for Wheel Center Cap AC-375TT
- Article: Trailer Wiring Diagrams
- Q&A: What is the Measurement from the Top of the Bolt Hole to Bottom of Cast Head Coupler w/ Jack Hole?
- Q&A: Replacement Rod and Nut for a Bulldog 12,000 lb Trailer Jack
- Q&A: Replacement Screw and Nut for Bulldog 10K / 12K Square Trailer Jack
- Article: Best Bike Racks for Electric Bikes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Hand Winches
- Article: How to Measure for Trailer Hitch Drop
Cyndi
12/28/2025
Thanks, I ordered the part and now just waiting for them to be installed on the trailer we just purchased. These should make it easier to load stuff on wheels. The spring will to replace the original spring.