Availability of Wiring Harness for Redarc Tow-Pro Liberty Installation on 2025 Nissan Frontier Pro4X

Updated 09/30/2025 | Published 09/27/2025

Question:

Hi! Will you let me know when you make a vehicle specific for the REDARC Pro To Liberty controller for a 2025 Nisan Frontier ProX4? I really want to avoid a universal part. Ill also want detailed instructions how to get an existing blank out Prying did not work. Thanks! Will

asked by: William D

Expert Reply:

Hey Will! The 2025 Nissan Frontier Pro-4X will have the same factory brake controller port as any other 2025 Frontier model. You can use the Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness # RED53CR. I don't have any specific instructions for removing the blank but it looks like you need to do it from the rear from what other Frontier owners have said. There are probably some tabs on the back to release it if you pull the entire panel where it is mounted.

expert reply by: Robin H

Custom Wiring Harness
(click to enlarge)

William D.

9/30/2025

I've found how to access the dash switches/blanks at the Nissan Frontier Forum. One Philips screw at the hood release area and gentle pulling to unclip the dash section. Then there are screws retaining switch groups and once those are out, it is obvious how to unclip each blank. Do not pry from the front!!! I see you do not offer a vehicle specific insert for the dash at the moment, are you planning to do so? I hear the 'universal' one is loose and cutting up a blank insert looks like a PITA.

Robin H.

9/30/2025

@WilliamD Redarc does not, just the universal. You can try adding the hole to the blank switch, if you mess it up it is probably inexpensive to replace. Personally, I would pick a good spot and put a hole in the dash to mount it over trying to use the universal mounting panel in that space. It will still look like an OEM part, we install a lot of them like this.

William

9/30/2025

@RobinH Gotchya. Thanks. Ordered the controller and harness today.