Replacement Disc Brake Pads for Deemaxx 3,500 lbs to 6,000 lbs Axle Calipers

Question

Question:

I need brake pads for disc brakes Deemaxx 3-6k. Number on caliper is 230607 169. Is “the DeeMaxx Ceramic Brake Pads with Steel Back Plates- 3,500 lbs to 6,000 lbs” the correct part?

asked by: Robert M

0

Expert Reply:

Yes, they are Robert. I checked with DeeMaxx and their Ceramic Brake Pads with Steel Back Plates-item # DE38VR are exactly what you need. These will replace one axles worth of brake pads.

What kind of trailer do you have?

expert reply by: Jerred H

0

Ceramic Brake Pads
(click to enlarge)

Bob

9/15/2025

Ace Trailers, INC GVWR- 10,400lb. dual axle, 5200lb/axle 10/20/2019

Jerred H.

9/15/2025

@Bob Boat trailer? Those are nice setups. Let me know if you have any additional questions down the road.

Bob

9/16/2025

@JerredH- yes boat trailer

Answer 1

Hey Doug, your bearing numbers don't match up with current 3,500 lb trailer axle bearing configurations so I don't believe we'd have a set of hubs for your axle that would work. With that said if you somehow did get idler hubs that ift…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Replacement Disc Brake Pads for Deemaxx 3,500 lbs to 6,000 lbs Axle Calipers

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching