Is Weigh Safe Flap Jack Sold Individually

Question

Question:

I just need one for the tongue of my RV. Are they sold as single units or only in pairs?

asked by: Dennis

0

Expert Reply:

Hey Dennis, we do sell a Weigh Safe Flap Jack individually with the part # WS48ER. What RV do you have?

expert reply by: Jameson C

0

Dennis

9/10/2025

We have a Coachman Freedom Express with a Lippert power tongue jack. I think the tongue weight is about 500 lbs.

Jameson C.

9/10/2025

@Dennis Flap Jack would work great for you. Plus it has quite the name haha.

Answer 1

Good morning Jess. The Weigh Safe Flap Jack Folding RV Stabilizing Block - 8" Tall - 6k #WS63ER is just the jack block itself, whereas the Weigh Safe Flap Jack Collapsible Trailer Jack Support and Shoe Scraper w/ Storage Bag #WS48ER is the jack…

view full answer...

Answer 2

The stabilizing jacks are all made overseas, and in regards to the capacities, they are on a per-jack basis. So the Scissor Stabilizer Jacks with Handle - 18-3/4" Lift - 10,000 lbs - Qty 4 #TJSCHD-24-4 have a 2,500 lb capacity per jack. The…

view full answer...

Answer 3

Hey there Nate, yes, the Weigh Safe Flap Jack Folding RV Stabilizing Block - 8" Tall - 6K #WS63ER will work great for your 2019 Grand Design Momentum 397TH that you say weighs 20,000lbs. The tongue weight / pin weight according to my sources…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Is Weigh Safe Flap Jack Sold Individually

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching