Does The Dexter Swing Away Hinge DX53CR Need To Be Welded On?
Updated 08/04/2025 | Published 07/31/2025
Products Featured in This Question
Question:
I see there are dexter outer units available for use with a-60 inners. with the plates attached. So how does the other piece attach to the tubing? Is that welded also?
asked by: Doug
0
Expert Reply:
What part is this in reference to, Doug? I know the A-60 is a brake actuator, but are you asking about the outer cover # T4324600, or something else?
If it's the # DX53CR swing-away hinge, then yes, it will need to be welded on both sides.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Dexter Swing-Away Coupler Hinge Kit for 3" x 4" Tongue - Weld On
- Folding Trailer Tongue
- Coupler Hinge Kit
- Weld-On
- 3 x 4 Inch Tongue
- Dexter
more information >
Continue Researching
- Video: Review of Dexter Folding Trailer Tongue - Weld On Swing Away Coupler Hinge Kit - DX53CR
- Shop: Dexter Swing-Away Coupler Hinge Kit for 3" x 4" Tongue - Weld On
- Search Results: swing away
- Shop: Dexter DX7.5L A-60 Brake Actuator - Bolt On - Drum - 2" Ball - Zinc - 7,500 lbs
- Q&A: Solution for Needing Replacement Caliper for Kodiak 204 Caliper
- Q&A: What Material Is The Dexter Swing-Away Coupler Made Out Of
- Q&A: What is Weight Capacity of Dexter 3 inch by 4 inch Hinge Kit
- Q&A: Replacement Inner Member Slide for LP7000 Actuator for Drum Brakes
- Q&A: Size of Spindle/Castle Nut for an 84 Spindle
- Q&A: Replacement Kodiak Brake Pads for Caliper Stamped with Kodiak 225
- Q&A: Can Fulton Fold-Away Coupler Hinge Kit Be Used On 1/4" Thick Trailer Tongue
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Hand Winches
- Article: Best Boat Trailer Jacks
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Mastering Tire Maintenance: Does Tire Pressure REALLY Matter?