Does Plywood Need to be Primed or Painted before Using Butyl Tape Adhesive

Question

Question:

I have some new plywood repairs in the roof, should it be painted or primed before installing the adhesive?

asked by: Steve

0

Expert Reply:

Hey Steve, it would not be necessary to paint or prime the plywood before using butyle tape like the part # 344270341411-1. There's nothing in the wood that would affect the adhesive. How bad was the wood rot?

expert reply by: Jameson C

0

Jameson C.

8/15/2025

Hey Steve, how did the butyl tape work out for your plywood repairs? I'm curious because it might help others facing similar roof repair situations.

Answer 1

Hey Kaleb, if you look at the inner portion of the Grease Seal Kit part #DX49CR you can see three lips/ridges. That is what is meant by triple lip. I attached a picture that has the section to look at.

view full answer...

Answer 2

Yes, they will! The Ultra-Fab Folding Spare Tire Mount for Trailers and RVs item #UF15-954730, you were looking at, will work great with an aluminum wheel. It mounts to 4" wide box style bumpers and fits 5-, 6- and 8-lug automotive and trailer…

view full answer...

Answer 3

To add a spare tire carrier to your Coleman 17b Travel Trailer, I recommend the Ultra-Fab Folding Spare Tire Carrier for Trailers and RVs item #UF15-954730. This carrier attaches to 4" x 4" square bumper. It works with all 5-, 6- and 8-lug…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

view full answer...

Answer 12

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Does Plywood Need to be Primed or Painted before Using Butyl Tape Adhesive

Product Page this Question was Asked From

Continue Researching