Solution for Needing Replacement Bulb for Gustafson RV LED Pendant Light # 277-000462-430

Question

Question:

Is there an option to just buy the plastic faux bulb that screws onto the light to hold the shade on? I have these exact lights in my rv but my father wanted to remove the glass shades when we moved the camper and lost the fake bulbs so theres nothing to hold the shades on to the lights.

asked by: Danielle

0

Expert Reply:

Hey Danielle, the Gustafson RV LED Pendant Light # 277-000462-430 that you referenced does have an LED "bulb" but it is not replaceable. It's basically has a board with 6 LEDs on it that produce light. The panel is not a standard type of bulb that could be replaced unfortunately. Only solution is the replacement pendent part # 277-000462.

expert reply by: Jameson C

0

Danielle

7/10/2025

When you but the replacement glass shade for these pendant lights, they aren't threaded. What holds the shade on to the light fixture?

Jameson C.

7/10/2025

@Danielle The cover of the LED diode panel that is tear shaped is threaded and it is what holds the shade to it. The shade goes on and then the threaded light cover holds it all to the base.

Danielle

7/10/2025

@JamesonC Gotcha that is the piece that I am looking for actually. The tear shaped threaded piece. My father took those off to remove the shades because he thought they would get broken on our move, but we couldn't find the threaded pieces when we got to our camp. Without that piece we have no way to secure the shades back on. I was hoping I could buy those individually rather than 2 complete pendant lights. Thanks for your help

Jameson C.

7/10/2025

@Danielle I see what you mean. I wish we could get them as a replaceable part but we aren't able to. You might try the manufacturer directly though.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Solution for Needing Replacement Bulb for Gustafson RV LED Pendant Light # 277-000462-430

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching