What Size Valve Stem To Get For Aluminum Sendel Series S20 Machined Trailer Wheel SEN94FR?

Question

Question:

Im looking to install internal TPMS on these rims. What size valve stem should I get?

asked by: John D

0

Expert Reply:

Hello John, thanks for reaching out. The Aluminum Sendel Series S20 Machined Trailer Wheel # SEN94FR take a 0.45" valve stem. I went out to our warehouse and measured one to be sure.

For a valve stem I recommend the Americana Metal, Bolt-In Valve Stem # AM20906. This works with both 0.453" and 0.625" rim hole sizes and they are rated for over 100 PSI.

expert reply by: Jesse M

0

Americana Metal, Bolt-In Valve Stem
(click to enlarge)

Jesse M.

9/2/2025

Hey John, did the Americana Metal, Bolt-In Valve Stem work out for your trailer wheels? I'm asking because it could help others who are looking to install internal TPMS on similar rims.

Answer 1

Hey Scott. The Kenda Karrier KR53 ST225/75R15 Radial Trailer Tire with 15" Silver Mod Wheel item #KE44WV comes balanced in the manner that trailer tires are balanced. Every tire and every wheel has a high (heavy) and low (light) spot. The…

view full answer...

Answer 2

Hello Juan, Thanks for writing in. Ford Ranger wheels can often work with the #E75SR axle because they usually share the same 6 on 5-1/2 inch bolt pattern. Many Ranger wheels are also 16 inches in diameter, which falls right into the size range that…

view full answer...

Answer 3

Hey Alan! You were right to think the Hydrastar Disc Brake Kit w/ Actuator for Tandem Axle Trailers #HYD44VR would fit your Curt axles. 5,200 lb to 7,000 lb axles have the same spindle measurements so those parts typically crossover. This kit has the…

view full answer...

Answer 4

Hey Chris, welcome back! The Hydrastar Disc Brake Kit w/ Actuator for Tandem Axle Trailers item #HYD44VR is exactly what you need for your 6,000 lbs axles with 6 lug hubs. This kit includes four rotors, an actuator, and all the brake lines you'll…

view full answer...

Answer 5

Hello John, thanks for reaching out. According to my research, the Atwood 8525-IV-DCLP is a 25,000 BTU furnace. We do have a 25K BTU unit from Dometic that can be used to replace this, but it would not be a direct replacement. Take a look at the…

view full answer...

Answer 6

Hello Kenneth, thanks for reaching out. We actually have several options for a 16x6 wheel with a 6 on 5-1/2" bolt pattern. Did you have a specific color of wheel type in mind. We have both aluminum and steel options. I have provided a link that…

view full answer...

Answer 7

According to my contact at Dexter Axle, their Trailer Hub and Drum Assembly #42866UC3-EZ fits a wheel with a 4-3/4-inch pilot hole and a 8-on-6-1/2 bolt pattern. Each hub carries a 3500-lb rating.

view full answer...

What Size Valve Stem To Get For Aluminum Sendel Series S20 Machined Trailer Wheel SEN94FR?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching